Remote Rig

RRC 1258 Support in English => Configuration, RRC 1258 => Topic started by: Dick N4RA on 2015-01-09, 16:34:43

Title: Newbie problem
Post by: Dick N4RA on 2015-01-09, 16:34:43

I have a K3 and K3/0 mini I'm just starting to integrate with Remoterig RRCs.  Since I'm not sure what to search for in the archives, I haven't found any help there yet.

I've been through the Elecraft setup including port forwarding of my ISP router (Verizon/FIOS).  When I push POWER on the control K3/0 the remote K3 powers up, but that's all that happens.  The audio on the control K3 sounds like a motorboat.  The VFO-B indicates TERM, but no other function works except POWER (control K3 goes off, but not the remote).  VFO-A works  for 2 seconds before TERM pops up and all controls stop working.

I'm at a loss for where to start debugging.  Any suggestions?
Dick

Title: Re: Newbie problem
Post by: dj0qn on 2015-01-09, 16:42:34

Dick,

Did you first get it working in the radio's network before moving offsite, or is this
problem in that network?

If you drop me a short mail at dj0qn (at) darc.de, I can send you my networking
checklist to help you find your problem.

73,
Mitch DJ0QN / K7DX

Title: Re: Newbie problem
Post by: N4RA on 2015-01-12, 22:29:21

Thanks, Mitch.
Thanks for the offer of help, Mitch.  I ran through your checklist (with some difficulty due to my noviceness).  I'm seeing the same symptoms: motorboat audio and unable to do anything on the remote unit.  VFO-B shows "TERM" after 2 seconds.

Anyone else have a suggestion?

Dick

Title: Re: Newbie problem
Post by: sm2o on 2015-01-12, 22:45:20

I tried to email you but the email address you have registered is not valid

/mike

Title: Re: Newbie problem
Post by: N4RA on 2015-01-12, 23:03:18

Sorry.  I didn't realize it was goofed up.  I fixed it.  e-mail is n4ra at aol.

Dick

Title: Re: Newbie problem
Post by: dj0qn on 2015-01-13, 02:26:05

Hi Dick,

I guess Mike will be getting back to you. Let me know if you need anything more
from my side.

73,
Mitch DJ0QN / K7DX