Remote Rig
RRC 1258 Support in English => Configuration, RRC 1258 => Topic started by: G4ABX on 2016-11-29, 17:03:43
-
Good afternoon all.
Bear with me, I'm still pretty new to RR operation!
I have a K3 at my 'remote' location and a K3S at my 'Control' location.
I have the system working.
I can TRX with SSB and CW using direct connections to my RR box at my 'Control' (or home) end. However for SSB I can only use VOX. PTT doesn't work for some reason?
I've worked a few 80M contests with the setup and whilst its not prefect its OK.
I also have N1MM partly working in that I can see the Remote K3 frequency and bandmap from my 'Control' station.
However, I cannot 'send' cw (or any other mode) from N1MM as I can when running my home K3S 'local' I need to use the paddle plugged into the 'Control' RR box to send CW
At present Com settings on my Control RR box are with Com1 set to "Mode 7, Cat to Com2 (remote)" and COM2 mode is set to 'Logical parallel with Com0'
Com3 mode is set to "Mode-10 Baudot RTTY'
I only see 'Com1' 'active' on my PC and that is what I selected as 'CAT' for the K3 in the N1MM configuration pane and is clearly displaying frequency and band map information.
So what do I need to do to get CW TX working from N1MM? (we'll worry about digital later!)
Has someone written 'setup' instruction for N1MM, RR boxes and K3 twins, as I'm pretty sure mine is not the first time this question has been raised?
Thanks
73
Bruce g4ABX
-
Hi Bruce
Have you seen this thread ?
http://www.remoterig.com/forum/index.php?topic=1536.msg16958#msg16958
N1mm works fine in all modes here
73,s Peder
-
Good afternoon Peder.
No, I hadn't seen that thread (although I thought I had been through everything!)
I'll try out the recommendations this evening and report back.
Many thanks
73
Bruce G4ABX
-
Success!
Many thanks for that thread.
I've now got N1MM+ playing with my RR setup.
Now all I need to do is get Digital modes working
73
Bruce G4ABX