Messages

1

General discussion forum / Re: Wireless Device (eg. Phone, Pads) - Program Mode

« on: 2012-03-27, 03:53:59 »

Thanks for the advice. But I was hoping to use one RRC 1258 as stand alone solution to remote control the radio in the same building.
Add this point I have my own PC server handling the audio streaming and the radio commands. Teamviewer and Skype are too much overhead.

2

General discussion forum / Re: Wireless Device (eg. Phone, Pads) - Program Mode

« on: 2012-03-26, 21:17:41 »

Thanks for the info. So, your handshake protocol is proprietary.
I wish you the best luck.

73 Jose

KP4FMD

3

General discussion forum / Wireless Device (eg. Phone, Pads) - Program Mode

« on: 2012-03-26, 16:30:56 »

RRC-1258

Which Program Mode I should use when sending data from a wireless device (such as phone, Pads, or any other programmable device connected to the network)? 0 or the one specified for the Radio (K3, Kenwood, etc). I am planning to use Remote Rig (Only One unit) to remotely operate the radio wireless in the same building.

If that possible? or I need another RRC-158 to send commands to another RRC-158 ?

Thanks

Jose L Rivera