Messages

1

General discussion forum / Re: SSL encription

« on: 2012-12-25, 13:21:02 »

Thanks for the response Mike. Guess my problem is somewhere else other than the RRC's

2

General discussion forum / SSL encription

« on: 2012-12-24, 20:50:51 »

Does anyone know if the 1258's are using SSL? While testing my Domain security I return something that shows an expired self signed ssl certificate. Issued by Mini Webservice Ltd.

3

Configuration, RRC 1258 / Audio transfer rate

« on: 2012-08-04, 01:52:25 »

Have everything set up and working well from the remote location. Rig FTDX9000D and remote end I am using a laptop with HRD and DM780. My favorite mode is PSK31 and occasionally have an issue with s slight skip in the audio data when listening to the audio. The slight skips in audio of course cause loss of data and makes copy sometimes difficult. May get a 100 ms pause every 2 to 10 seconds. I realize this could just be an internet traffic issue. Have good high speed service on both ends. Just checking to make sure there are not some tweaks that can be made to the 1258's to help with this or something else I may be missing.
Thanks for any help

4

Configuration, RRC 1258 / Re: DMZ setup

« on: 2012-07-24, 16:00:46 »

Thanks to both of you for the help - think I have everything configured and everything seems to work well, just have not taken it to the control rig on the trip yet  .

5

Configuration, RRC 1258 / DMZ setup

« on: 2012-07-23, 16:27:11 »

Does the router on the control end need to to be configured with the RRC in a DMZ also?

6

Configuration, RRC 1258 / Re: Data Transfer

« on: 2012-07-21, 16:50:54 »

Thanks Dirk - works perfectly now - appreciate the help.

7

Configuration, RRC 1258 / Data Transfer

« on: 2012-07-21, 13:58:45 »

This is my first experience with Remoterig so I will admit to being a novice here. I am setting up a pair of 1258MKII's and have them sitting side by side it the test mode along with my Yaesu FTDX9000D. Because of the cost of the rig I cannot afford to have a duplicate on the control end so I am planning on using a Toshiba laptop running windows 7 with HRD for rig control and DM780. My favorite operating mode is PSK31 and and the sound card in my laptop does not seem to be recognized by DM780. I have a US Interface Navigator that I use with MixW when at the home QTH so I am using that basically as a external sound card feeding audio to the control side of remoterig. The problem I am experiencing is that on transmission, the rig stays in transmit but the audio comes to the rig in about 250ms bursts about every 3 seconds - not an intermittent issue, happens like clockwork. If I feed the audio from the Navigation directly to the rig everything works fine so it definitely seems to be an audio transfer issue between the two remoterigs. I would appreciate any suggestions?