Show Posts
1
Configuration of Routers, Firewalls, etc / WIFI mod fails to save config.
« on: 2012-09-15, 02:32:39 »
Hi,
I have now successfully connected remotely 2 x RRC's inside my network both via Eth and via wnce2001 with Mitch DJ0QN / K7DX 's kind assistance.
Once I removed the eth and the wnce2001 from the control RRC (not installed at the same time) and installed the WIFI mod, now when using the Microbit Manager V1.17, I can scan and successfully see my wifi router (and my neighbors) but it fails to save the config when I select it by the radio button "Failed saving setup info: Invalid ACK: 0".
I can also only assume the WIFI card uses the same MAC as the RRC Control as I can't find any other MAC listed either in the Manager or on the web interface.I need to add the MAC to my trusted list in my router.
Now the power light is flashing probably indicating a network connection error because of the WIFI Card.
Has anyone seen this anomaly and have a fix?
Both RRC's are updated to the latest firmware.
Thanks
Glenn, vk1nut AKA "Nutters"
I have now successfully connected remotely 2 x RRC's inside my network both via Eth and via wnce2001 with Mitch DJ0QN / K7DX 's kind assistance.
Once I removed the eth and the wnce2001 from the control RRC (not installed at the same time) and installed the WIFI mod, now when using the Microbit Manager V1.17, I can scan and successfully see my wifi router (and my neighbors) but it fails to save the config when I select it by the radio button "Failed saving setup info: Invalid ACK: 0".
I can also only assume the WIFI card uses the same MAC as the RRC Control as I can't find any other MAC listed either in the Manager or on the web interface.I need to add the MAC to my trusted list in my router.
Now the power light is flashing probably indicating a network connection error because of the WIFI Card.
Has anyone seen this anomaly and have a fix?
Both RRC's are updated to the latest firmware.
Thanks
Glenn, vk1nut AKA "Nutters"