Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - sm2sum

Pages: [1] 2 3 4
1
Configuration, RRC 1258 / Re: RRC and XPLORNET
« on: 2017-10-07, 20:56:50 »
Maybe another option if you have problems with double nat
 http://dovado.com/en/features/bridge-mode :)

Good luck...

Peder

2
General discussion forum / Re: JT65 and Latency
« on: 2017-03-01, 15:20:33 »
Paul
I have k3 twin remote using RRC 1258 and have done some  JT65 using wsjt-x.
Have not tried JT9 yet but can decode both JT65 and JT9 at the same time up to 4 khz. I can also transmit both easy with my setup.
Push and toggle..... tx jt65¤....just under  monitor and erase buttons
Good luck
Peder

3
General discussion forum / Re: JT65 and Latency
« on: 2017-02-28, 22:01:55 »
Paul
Change Bins/pixel to 5 on WSJT-X  wide graph window and you will have 4khz.
 I am using audio quality 2....... Full duplex no....... RTP tx mode normal.....
And dual rx no in radio settings
Peder sm2sum

4
Configuration, RRC 1258 / Re: RR and N1MM for K3 Twin setup
« on: 2016-11-30, 14:31:47 »
Hi Bruce
Have you seen this thread ?
http://www.remoterig.com/forum/index.php?topic=1536.msg16958#msg16958
 N1mm works fine in all modes here

 73,s Peder

5
System message after reboot :
Saved error message:
Data Abort at 0x000541b0, called by 0x0000a9c4



6
I am using ping watchdog but it does not help.....

7
Happens for me also and I know one more with the same issue.
Setup manager finds the RRC but can not browse so  a reboot is the only way.
Still all works 100 %.....

8
General / Re: App Trial Period Has Expired
« on: 2016-05-09, 14:27:56 »
All OK here also

Tnx sm2sum

9
General / Re: App Trial Period Has Expired
« on: 2016-05-09, 12:57:18 »
Just checked again.
Audio s-meter and filters works at start.
And after about 4 minutes delay all functions works.
Did not wait solong time before sri

Peder

10
General / Re: App Trial Period Has Expired
« on: 2016-05-09, 11:31:48 »
Nothing works here except filters
and no audio
Peder

11
Allmänt diskussionsforum / Re: Trött på min RemoteRig
« on: 2016-04-25, 20:01:27 »
Ibland räcker det inte med att bara ha abonnemang heller.. man måste även ha  mobilpinne eller router med operatörens mjukvara .
Jag har haft samma operatör sen 2007 men när jag provade med några 4G-pinnar från
Ebay som inte var operatörslåsta blev dom natade direkt.
Och att få supporten att registrera IMEI koden var omöjligt......

12
Feature Requests / Re: Bluetooth Headset Capability
« on: 2016-01-15, 21:10:45 »
Try the  rigs   compression off ...and a lower  level on ALC that should help a lot..

/3,s Peder

13
General discussion forum / Re: Device Disconnected message
« on: 2016-01-02, 10:04:16 »
HNY
Works on my 64 bit win 10 now also ,so last update really did the job..

Tnx Peder

14
General discussion forum / Re: Device Disconnected message
« on: 2015-11-19, 20:00:28 »
That is OK for me.

Went back to 1.27 and it works fine on win 10.....tried 1.28 again but no luck.

Installed 1.28 on an old laptop with Vista but not working there either.
1.25 and 1.27 works.

Peder


15
General discussion forum / Re: Device Disconnected message
« on: 2015-11-18, 18:45:23 »
Yes that is correct...one more Usb unit appears

Pages: [1] 2 3 4