1
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Hi Simon,
I send you some photos from my mechanical and electric solution with HEDS-5640
73
Willi
I am using homebrew board too:
tuningknop with 5 cm diameter and HEDS-5540 #A06, optical encoder, 500 CPR, 6,35mm axle (1/4") (look at E..ay.de) wired to the encoder inside the RC 2000 panel.
The encoder use 5 Volt DC from the RC 2000.
http://www.datasheetcatalog.org/datasheets/270/77838_DS.pdf
73
Willi