Messages

1

Hardware, Cabling, Installations / sw 1289 auto switching

« on: 2015-06-10, 22:35:15 »

Need help getting the auto switching to work;  set up with ts 480, can select and switch  antennas via the software manually and all is well, but when auto is selected there  is complete silence in the radio indicating no antenna is selected.  Thanks Phil

2

Hardware, Cabling, Installations / antenna switch as 1289

« on: 2015-01-27, 23:18:01 »

Hello,  I love using my remote rig with ts 480; this question may show my ignorance but so be it;  the ts 480 has two antenna connections and I use an ALS 600 amp which only has one in and one out;  therefore I run my hexbeam thru the amp and my 80 meter dipole barefoot using the ts 480 internal antenna switch;  would it work  to run the ALS 600 out to the AS 1289 and have the two antennas set up as one and two on the AS 1289;  if so would the switching still be automatic or would I have to access the setup when I want to change from the hexbeam to dipole;  I hope I am clear on this.  Thanks Phil

3

Configuration, RRC 1258 / trouble connecting remotely

« on: 2014-09-02, 22:12:14 »

Hello,  I have a ts 480 and can get the units and radio to work at my qth;  when I go to another site, the control device says "not reachable" and radio only beeps a couple of times and will not turn on.  Any help is greatly appreciated.  Thanks Phil

4

General discussion forum / Re: repair

« on: 2014-08-14, 18:11:19 »

HRO is replacing the unit.  Thanks, Phil

5

General discussion forum / Re: repair

« on: 2014-08-12, 18:21:36 »

I tried the 12 v, the 110 adapter and usb;  I contacted HRO Virginia where I bought it and they said to contact RemoteRig at mikael@styreors.se which came back as invalid.  Phil

6

General discussion forum / repair

« on: 2014-08-12, 17:07:19 »

Where does one send a unit that does not power up for repair?  Thanks Phil

7

General discussion forum / warranty product support

« on: 2014-08-11, 22:30:13 »

Please advise warranty procedure; my radio unit will not power up using 12v, 110 adapter or usb, less than 2 months old.  Thanks, Phil

8

Configuration, Webswitch 1216H / setting initial ip address

« on: 2014-07-02, 21:19:05 »

I am trying to follow the instructions on the initial set up but I do not know what to use for the remote rigs to communicate with my computer;  my computer's ip is 192.168.50.10, 255.255.255.10, and 192.168.50.1
Any help is greatly appreciated.  thanks, Phil