Messages

1

General discussion forum / Re: webswitch 1216H can not create virtual port

« on: 2015-12-05, 19:38:11 »

Thanks Jan for your reply. It is working great now!!

73, Fred/PA8F

2

General discussion forum / webswitch 1216H can not create virtual port

« on: 2015-12-04, 21:21:00 »

I can not create a virtual port with setup manager v1.28.

Have set the serial settings in the Webswitch to:
Remote serial (RFC2217/Raw): Server
Remote serial mode: Normal
Remote serial timeout(secs): 3600
Remote serial TCP port: 11182
Remote serial host/IP: empty
Remote serial DSR: No
Remote serial CTS: No

In the serial port setting of the setup program is use:
Serial port: COM2 (in the drop down menu i have the choose between COM1, COM2, COM3
IP Address/Host Name: 192.168.178.52
TCP port: 11182

After create I get the message Serial port created/updated! Port status is then Not installed

mblog.txt shows:
4-12-2015 21:15:55 *********************************************************
4-12-2015 21:15:55 *** Program Start version 1.28.0.0
4-12-2015 21:15:55 *** Date: 4-12-2015
4-12-2015 21:15:55 *** Time: 21:15
4-12-2015 21:15:55 *********************************************************
4-12-2015 21:15:55 Date=vrijdag 4 december 2015
4-12-2015 21:15:55 Time=21:15:55
4-12-2015 21:15:55 .NET=4.0.0.0
4-12-2015 21:15:55 Versions
4-12-2015 21:15:55   Setup Manager=1.28.0.0
4-12-2015 21:15:55 COM Ports

Running Windows 10

Need your advice to solve this.

73, Fred/PA8F

3

Configuration of Routers, Firewalls, etc / Ipv6 at radio end

« on: 2014-11-19, 18:55:06 »

Hi all,

I'm new to RR and have read a lot on this forum and the manual. I understood that Ipv6 is not supported yet. So I was wondering since I must choose a new ISP on the radio end and the changes are that this will be an Ipv6 how to handel this.
Will DynDNS or the DNS service of RR be able to handel Ipv6 on the radio end?

73, Fred/PA8F