My remote setup was working fine untill 2-3 last weeks.
For a reason that Im not know the connection between Control
and Remote loost from time to time but the audio pass with fair results as my Internet is not so fast.
Then, the connection problem come more and more unstable and the audio dissappears.
I buy the the Nano app for my smartphone and the audio pass and work fine but no on my Control box speaker.
I make many combinations but nothing. Here is my setup:
REMOTEInfo
Name Value
Company Microbit
Product 1258
PID 4
Version 5
HW 6
Software 2.84
Bootloader 1.9
Compiler 4.6.2
Build Jan 20 2015 15:18:28
ROM/RAM 472308/41972
ETH-RAM 2944 (max 3kB)
USB-RAM 15348 (max 16kB)
Battery-RAM 4
ResetSrc 0 [3]
Last WD Reset 3860867176
Uptime 0 Days, 3 Hours, 32 Mins, 25 Secs
Serial number 4188
MAC address 00:1e:fd:01:86:fc
IP address 192.168.1.74
Netmask 255.255.255.0
Gateway 192.168.1.1
DNS 8.8.8.8
Wi-Fi network module not present
Settings
Unit ID (Banner) SV5BYR TS-2000 Istrios
DHCP 0
IP 192.168.1.74
Netmask 255.255.255.0
Gateway 192.168.1.1
Dns server 8.8.8.8
Eth-type 0
IP-interface 0
Web page user xxxxxx
Web page pwd xxxxxx
Web page user(saving)
Web page pwd(saving)
Program mode 4
Control panel 0
Sip password xxxxxxxxxxxx
Sip contact xxxxxxxxxxxx
Auto connect 0
Audio quality 0
Audio dual-rx 0
Audio left/right ch swap 0
Codec out gain 255
Codec inp gain 0
Codec inp HPF Hz 3
Codec inp preamp 1
Codec inp attenuation 0
COM0 baudrate 57600
COM0 data bits 8
COM0 stop bits 1
COM0 parity 0
COM0 Program mode 3 char timeout 2
Use USB Com Port as COM0 0
COM1 mode 6
COM1 baudrate 57600
COM1 data bits 8
COM1 stop bits 1
COM1 parity 0
COM1 rts/cts 0
COM1 terminator (hex) 00
Use USB Com Port as COM1 0
COM2 mode 4
COM2 baudrate 57600
COM2 data bits 8
COM2 stop bits 1
COM2 parity 0
COM2 terminator (hex) 00
Use USB Com Port as COM2 0
COM3 mode (USB-COMFSK) 10
UDP cmd port 12000
UDP audio port 11000
SIP port 5080
Web server port 8080
Telnet server port 23
Rx jitter buffer size 4
Rx jitter delay 3
Audio packet size (ms) 20
RTP tx mode 0
Disable audio tones 0
Audio tones -db [70-0] 30
IP identification (morse) 0
Full duplex 0
PTT-off mute delay 0
IP Type-of-Service (dec) 0
Yaesu power-on/off 0
UDP antenna-switch port 13010
UDP cmd min-data-size 0
Use common network settings 0
Check interval 10
DDNS Host name 1
Own host name xxxxxxxxxxx
Username xxxxxxxxxxxx
Password xxxxxxxxxxx
Enable 0
Speed wpm [0/10-40] 0
Iambic 1
Paddle reverse 0
Weight [25-40] 30
Side tone hz [0,300-1500] 800
Side tone -db [50-0] 20
Lf delay ms [0-500] 0
Key delay ms [0-250] 0
PTT activated by Keyer 0
PTT tail delay ms [0-999] 800
Speed pot min wpm [5-99] 10
Speed pot max wpm [5-99] 40
IN0 mode 0
OUT0 mode 1
OUT0 mode 1
OUT1 mode 1
OUT1 mode 1
OUT2 mode 1
OUT2 mode 1
USB RTS as PTT 0
USB DTR as CW 0
Enable ping watchdog 0
IP address to ping
Ping interval (seconds) 300
Startup delay (seconds) 300
Failure count to reboot 3
1: Name (SSID)
1: Password (PSK)
2: Name (SSID)
2: Password (PSK)
3: Name (SSID)
3: Password (PSK)
4: Name (SSID)
4: Password (PSK)
5: Name (SSID)
5: Password (PSK)
6: Name (SSID)
6: Password (PSK)
7: Name (SSID)
7: Password (PSK)
8: Name (SSID)
8: Password (PSK)
Status
Name Value
Radio ON
Connection status Disconnected
SIP status Idle
Last SIP error None
RTP/UDP audio status Disconnected
UDP cmd status Disconnected
SIP command timeout 0
Rx Jitter buffer size 4
Rx Jitter delay 3
Dual Rx 0
External IP 94.66.99.171
SIP Out port 5080
SIP In port 5080
Audio Out port 11000
Audio In port 11000
Command Out port 12000
Command In port 12000
External SIP In port 5080
External Audio In port 11000
External Cmd In port 12000
Other party 62.103.28.168
Input 1 High
Input 2 High
Output 0 Low
Output 1 Low
Output 2 Low
Dynamic DNS status OK
Ping status (watchdog) Off
DNS status OK, remoterig.com = 213.180.92.125
Active profile Default
PTT status OFF
Antenna-Switch (IP) not connected
Common network settings No
CONTROLStatus
Name Value
Control panel OFF
Radio OFF
Connection status OK
SIP status Connected/transfering
Last SIP error None
RTP status Excellent(60)
UDP cmd status OK(45)
SIP command timeout 0
Rx Jitter buffer size 4
Rx Jitter delay 3
Dual Rx 0
Current audio packet size 20
Current audio quality 0 - alaw 8 kHz
SIP Out port 5080
SIP In port 5080
Audio Out port 51540
Audio In port 11000
Command Out port 12000
Command In port 12000
External SIP In port 5080
External Audio In port 11000
External Cmd In port 12000
Other party 2.87.127.72
Input 0 High
Input 1 High
Input 2 High
Output 0 High
Output 1 Low
Output 2 Low
DNS status OK, ldlscilp.ddns.remoterig.com = 2.87.127.72
Active profile Default
PTT status ON
Common network settings No
any idea....
Show Posts