Messages

1

General discussion / Re: ftsprapi.dll error in Win7Pro

« on: 2016-05-24, 18:38:32 »

Thank you very much for the assistance!

I am sorry to be such a wuss, I am going to make a full description for future reference...

All the best!

Steve HA0DU

2

General discussion / Re: ftsprapi.dll error in Win7Pro

« on: 2016-05-24, 18:27:08 »

YEEEEEEEEEEEEEEEEEEEEEEEEEEEEEEAAAAAAAAAAAAAAAAAAAAAAAAH!

3

General discussion / Re: ftsprapi.dll error in Win7Pro

« on: 2016-05-24, 16:35:44 »

Hi Jan,

See the attachment for the settings.

Steve

4

General discussion / Re: ftsprapi.dll error in Win7Pro

« on: 2016-05-24, 15:21:13 »

Hi Jan,

Oh yes, I am trying to fix whatever I screwed up before...

Yes, I do see the three (COM 2, 3 and 4) virtual COM ports listed in Device Manager.

However, checking features, In General it says This device is working properly, but in Resources it says This device is not using any resources, because there is a problem. Is this something that refers to a problem to be solved?

Steve

5

General discussion / Re: ftsprapi.dll error in Win7Pro

« on: 2016-05-24, 15:02:55 »

Update at 14:57 on May 24.

The reason for "request timeout was that the owner turned off the power at the radio side...
Now that the RRC is operational, I get a "Connected to SIP: ....." message very quickly.
The radio side is an FT-2000 connected via a Microbit RRC-1258-MKII.
Then comes the next problem: I start PCC-2000, and no matter whatever COM port and baud rate I set up, the response is always the same after pushing the COM button: "Failed to connect the COM port."

So we are close, but not there yet...

Steve HA0DU

6

General discussion / Re: ftsprapi.dll error in Win7Pro

« on: 2016-05-24, 12:39:56 »

Dear Jan,

Thank you for your response.

The "About" box shows the following:

RRC-Micro 1.9.2.0
Audio 1274A 2.1.0.0 Firmware 0
RTP 1.2.0

When I did the installation according to the instructions ( 1274A disconnected, install as Admin), the program seemed to install (no error messages at least).
However, somewhere the computer stored the settings, as the newly installed program  comes up with the port settings I did before.
No matter how I set COM 0 (any of the three virtual COM ports), I always get "Request Timeout".
I turned Debug on, however there is no separate debug log, so I send you the one which I have.

73 Steve HA0DU

7

General discussion / ftsprapi.dll error in Win7Pro

« on: 2016-05-23, 18:34:59 »

HI All,

I am trying to use a Remoterig 1274A with a computer, which has Win7 Professional. The radio end is most probably OK, as its owner has used it for about two years.

When I install RRCMicro, I get this error message (see attachment).

I read the previous comments on this topic, and tried to re-install, etc. but the result is always the same, installation stops and no COM ports are available in the Client.

I am not a computer expert, please consider that when you phrase your answer...

73/DX Steve HA0DU