Messages

1

General discussion / Problem RRC Micro to IC7100

« on: 2019-02-02, 21:11:55 »

I am connecting my cell phone to my IC7100 to participate in my ham club's weekly net.  All worked fine until the club decided to add a tone to access the repeater.  I can set up the VFOA on my radio to use the tone, but it gets reset to no tone when I disconnect.  Therefore, I can use it once only!  Then I have to visit my base radio and set up the tone access again.  Is there any way to specify what gets sent to the radio at connect or disconnect time by accessing a file?  Can the disconnect data that is programmed in the radio NOT send the CI-V command that resets the tone?  Thanks.  Dennis NR6J