Messages

1

General discussion / Re: TS-480 now working great

« on: 2016-06-18, 08:47:33 »

Major thanks to Mike, sm2o, for his assistance in getting my RemoteRig station up & running . After looking at my setup, Mike quickly determined what the problem was and it's now working on my home network as I test it a couple days before relocating the hardware to the remote site. I'm hoping that configuration will go smoothly and I'll be back on the air again after a very long hiatus of not being able to have an antenna where I live.

I also want to thank Mitch, dj0qn, for sharing your 'network checklist'. I'll definitely refer to it when I reconfigure the hardware for the remote site 


Randy
KE4RWS

2

General discussion / Re: TS-480 control head beeps but won't power up radio

« on: 2016-06-17, 23:13:56 »

Turns out I did have the ddns hostname for the SIP Contact but upon reading your message I changed it to the local radio IP but I'm still getting the 3 beeps when I trying turning on the TS-480 control head so there must be something else affecting it. I have already PM'ed the exported settings(html) files from both units for your perusal and sincerely thank you for any assistance you can provide


Randy
KE4RWS

3

General discussion / TS-480 control head beeps but won't power up radio

« on: 2016-06-16, 16:11:21 »

I've been working with my new RemoteRig RRC-1258 boxes but I must be doing something wrong. Every time I push the button on the TS-480 control head it beeps three times, three times in a row and fails to turn the remote transceiver on. I have both the Control and Radio boxes hooked up to the same network while I  configure and test the setup before relocating the TS-480 radio chassis to the remote site. I've gone through the manual again and again and AGAIN but find it somewhat lacking in that it doesn't seem to have a lot of clarity in explaining certain processes. I have logged on to and configured both RRC-1258 boxes and the settings seemed fairly straightforward. As it is now I'm stuck and cannot get it to work. There are no error messages of any kind (aside from the strange 3-beep issue when I try activating the control head). I believe I have both the Control and Radio boxes configured correctly but it just isn't happening. I was hoping maybe someone could give me some pointers 

Randy
KE4RWS