Messages

1

General discussion forum / Re: LCD Refresh on K3 / K3/0-Mini config

« on: 2017-10-16, 16:59:10 »

Since I assume no one else has seen this issue, is there a better support channel to open a ticket with RemoteRig than this forum?

Thanks

2

General discussion forum / Re: LCD Refresh on K3 / K3/0-Mini config

« on: 2017-10-08, 16:12:10 »

Has anyone experienced this or have any ideas on what I might check. My connection is fine for audio so I do not believe it is related to the network speed.

3

General discussion forum / Solved - Can I change all the menus on the K3 Radio side with the Control side?

« on: 2017-10-08, 16:11:20 »

I solved this one...It was a silly operator error that I saw right away when I was at the actual station Friday night. I was trying to change the mic setting in CW mode. When you do that on a K3, the radio scrolls a message on the secondary display line that reads "N/A in CW". The reason I could not see that is related to my other issue where the display takes a long time to refresh. I was never able to read the "N/A in CW" line. I have not solved that one yet.

Thanks for the help and now to try to figure out the second issue.

4

General discussion forum / Re: Can I change all the menus on the K3 Radio side with the Control side?

« on: 2017-10-05, 15:31:34 »

OK. Well I am not able to change the menu settings while connected so something is wrong. Thanks for verifying that I should be able to change all the menus though on the radio at the remote site.

Thanks,

Tom

5

General discussion forum / Re: Can I change all the menus on the K3 Radio side with the Control side?

« on: 2017-10-05, 05:28:37 »

Hi Mitch,

It is the radio side I want to change (the remote side at the club house). I was trying to change the menu when connected to the remote.

I do not believe I would want to change the local K3 Mini as I need the remote side to use the rear panel mic input.

Tom

6

General discussion forum / Can I change all the menus on the K3 Radio side with the Control side?

« on: 2017-10-04, 18:28:40 »

I realized that I forgot to set the mic input to REAR on the radio K3. I connect with the control K3 Mini and enter the config menu. I can see the item but am not able to change anything. If I push 1, 2 or 7 to adjust certain settings, nothing changes.

Are any menu settings locked out from the control side?

Thanks,

Tom NY4I

7

General discussion forum / LCD Refresh on K3 / K3/0-Mini config

« on: 2017-10-04, 18:26:42 »

Hello, I searched but could not find anything. I have audio passing between the two RR devices between a K3 and a K3/0 Mini just fine. I have noticed that if I go into the K3 menu system (while connected so the Radio side menu) that the LCD lags far behind with many artifacts on the control LCD. Various LEDs light as well as many different items on the display. According to the RR devices, the connection is excellent. Does anyone have an idea what would cause this to happen?

Thanks,

Tom NY4I