Messages

1

Configuration, RRC 1258 / Re: RRC-1258 and Yaesu FT-857

« on: 2018-07-28, 19:33:08 »

OK, I put the RRC-1258 on a small lead acid battery and that resolved it.

What do you think about putting a diode in series with the positive power lead and a (large) capacitor across the 1258 power lead?

What is the cutoff voltage for the 1258?

2

Configuration, RRC 1258 / Re: RRC-1258 and Yaesu FT-857

« on: 2018-07-26, 18:41:38 »

Let's try this for a third time....
Part 1 of 2.

3

Configuration, RRC 1258 / Re: RRC-1258 and Yaesu FT-857

« on: 2018-07-24, 18:01:42 »

Yes, I have the correct IP addresses. 

The remote site indicated the SIP is stalled while the radio side shows disconnected. 

4

Configuration, RRC 1258 / Re: RRC-1258 and Yaesu FT-857

« on: 2018-07-24, 02:55:40 »

OK, I factory reset both units and re-programmed them.
I checked each jumper on both units on the AUX/MIC configuration (and rang them out with a meter).
The remote side only has Jumper 3 in and the radio side also has jumper 3 for the Yaesu FT-857.
No Luck.

I put both units on different power supplies. No joy.
I used a crossover cable for the connection between them (both on the same subnet) and still no luck.

I swapped the TTL cables with the radio & control boxes (with the yellow connector toward the 1258 in each case) and it still doesn't work

If I put the FT-857 head back on the radio, it works with the radio.

Any ideas before I return the system?

5

Configuration, RRC 1258 / Re: RRC-1258 and Yaesu FT-857

« on: 2018-07-18, 03:01:49 »

OK, the router's SIP AGL is disabled and the IPv4 firewall is disabled. Still no joy.  I see the 857 screen start to come on, but then it goes out.  The relays click in the radio base, but nothing on the remote head.

What are the next things I need to check??  How do I know if the 1258 is working as it should?

6

Configuration, RRC 1258 / Re: RRC-1258 and Yaesu FT-857

« on: 2018-07-17, 13:41:39 »

Does the ISP and Firewall come into play even if both units are inside my network?
The two 1258's are two IP addresses (192.168.2.130 & 192.168.2.132) from each other and don't leave the network.

7

Configuration, RRC 1258 / RRC-1258 and Yaesu FT-857

« on: 2018-07-17, 05:16:19 »

I am trying to get a Yaesu FT-857 to connect to the base unit using the 1258.
Both sides of the 1258 are on the same switch and same subnet.
The remote unit tries to connect to the base (I can hear the relays click), but the display on the control head doesn't light up.  The remote side web page connection status indicates a faulty connection, the SIP Status shows Connected/transferring, but the RTP/UDP audio status is Stalled. 

Any ides where I should start to look??

tnx
de ka9hnt