Messages

1

Hardware, Cabling, Installations / Re: Kenwood TS-480 with RRC-1258MkII Radio unit, and RRC-1258 ver 1 Control unit.

« on: 2019-06-03, 15:15:27 »

Hello again,

I have double check the red wires and the codecs, i checked them with ohm meter and i changed all of them just in case. the problem seems to be at the wire of my RRC-1258 Ver1. Every cable that i fixed the result is the same, display works perfect, PTT is working fine and modulation works, but when i stop talking to mic with PTT pressed a strong noise pass through my modulation, I Tried different capacitors bigger than 1μF at MIC as you suggest at your design with no better result. I was using those units with an Icom 706MkIIG without any problem. Please help me find what is wrong, Is there any other cable design for my old RRC-1258 ver 1 to eliminate this kind of interference on my modulation?

Thank you for you help.

Sv1gfu

2

Hardware, Cabling, Installations / Kenwood TS-480 with RRC-1258MkII Radio unit, and RRC-1258 ver 1 Control unit.

« on: 2019-06-02, 14:11:17 »

 I own one new Radio unit ( RRC-1258MkII ) and one old Control unit ( RRC-1258 ver 1 ) and i am trying to connect those two units with Kenwood TS-480. I already saw and fix the cable for RRC-1258 ver 1 control unit http://www.remoterig.com/v1/bilder/TS480-RRC-Radio-K6.pdf, and i put the correct jumpers at Radio unit ( RRC-1258MkII ) and TTL is connected with control plug, and AUX/MIC with the MIC plug on my TS-480 main unit.
With this connection and the cable i fix from your design at  RRC-1258 ver 1 page , i manage to turn on and control TS-480 from my old RRC-1258 ver 1 control unit, but i have strong noise when i try to transmit, The base goes to PTT mode but with a lot of noise. Please advice me what can i do in order to fix this problem of mine.