Messages

1

Allmänt diskussionsforum / Re: Remoterig Kenwood TS480 through mobile router TPlink Archer MR600

« on: 2024-10-10, 13:57:33 »

Hej igen,

Routern har fått samma adress från ISP som whatsmyip.org visar (178.31.xx.xxx ), så tycks inte vara det som är problemet..
/B

2

Allmänt diskussionsforum / Re: Remoterig Kenwood TS480 through mobile router TPlink Archer MR600

« on: 2024-10-10, 13:32:12 »

Hej,

Tack för återkopplingen! Ska kolla. ISP = Telenor.

/B

3

Allmänt diskussionsforum / Remoterig Kenwood TS480 through mobile router TPlink Archer MR600

« on: 2024-10-10, 12:47:01 »

Hi!

I am trying to set up remote rig  according to the above configuration. All seems to be set up correctly.  The ddns information is recognized by the controller (panel) side, i.e. the host address is shown in the status information on the controller!

So the LAN/network should be Ok but still the communication  between the controller and the host (radio) is not working. When I press the power button a peep sounds after a while. I have checked the SIP passwords, they are equal.

When i connect the controller directly to the tp-link router (to same LAN as the radio) it works ok.


What more can I do/check.

73 de Björn

4

General discussion forum / Re: How to connect Bencher BY-1 paddle to RRC1258 V2 (early version from 2016)?

« on: 2023-04-28, 09:25:09 »

TU mike,

I got it working now. In addition I had to change setting 37 in my TS480 from OFF to ON. This setting controls the internal electronic keyer function. In ON state the keyer become half automatic (bug-mode according too manual) which mean that the dashes has to med generated externally. The dots are still generated by the electronic keyer. So in this case the dashes are generated by the "remote" panel rrc. According to the manual the dots are still generated by the TS480 and assumable also by the "remote" panel rrc which is a bit confusing that it not is causing conflicts which it seems to not be doing. Anyway it works now and the output from the radio when using remoterig is working as it should.

73 de SA0TJS

5

General discussion forum / How to connect Bencher BY-1 paddle to RRC1258 V2 (early version from 2016)?

« on: 2023-04-26, 11:29:09 »

Hi! Anyone who knows if this is possible? Cables are built according to available drawings.
I have tried almost every combination of the IO port settings. I got this suggestion from SM0CXU who has the latest Mark II version:
Control panel side:
INO Mode: I/O
Out 0 mode: Connect
Out 1 mode: I/O
Out 2 mode: Keyer
RTS Disabled
DTR Disabled


On the radio side I have tried almost every combination.

What happens is the output either is dot dash dot dash etc ... independent of which paddle I press, or with some I/O combinations I get either only dots or only dashes independent of paddle pressed.

I get the impression that connection over the rrc is not capable of separating the dot line and the dash line   which results in that signals are treated as a squeeze of both paddles which is not the case.

My radio is Kenwood  TS480 SAT

Any ideas?