1
Configuration, RRC 1258 / Re: IC7100: first setup failed
« on: 2024-04-26, 16:34:33 »
Thanks Mike for fixing my issue. The baudrate for com0 was not set to 38400. Now it works great.
73s, Tor
73s, Tor
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: [1]
2
Configuration, RRC 1258 / IC7100: first setup failed
« on: 2024-04-21, 17:53:21 »
Hello OMs,
after a long time I have finally tried to get my remote setup up and running with an IC7100 (s/n 03004287). Unfortunately I can't do it. When I want to switch on the TRX, I hear a soft crack in the speaker of the controller and the two orange SIP LEDs start to light up for about 2 seconds. Then the LEDs switch off again and the TRX does not switch on.
I have now checked many things and also changed the cables, but the status remains the same. The following setup situation at the moment:
Radio and control unit are in the same IP subnet on a switch. Both have an IP, both can be operated in the browser. The control unit has the IP of the radio unit as its SIP contact. The controller reports the IP of the radio unit as "other party" in the status.
I have initially set or adopted the default settings for the 7100 everywhere. The jumpers are set according to the instructions and the red cables are plugged into the radio unit. There is a circuit board for the newer version of the IC7100 in the control unit, it is plugged in correctly with the slanted corner at the top right. Both units are connected to the same power supply, which should be sufficiently large at 25A.
I simply have no idea why the system won't start. Who can help me?
73s de Tor
DM1TS
after a long time I have finally tried to get my remote setup up and running with an IC7100 (s/n 03004287). Unfortunately I can't do it. When I want to switch on the TRX, I hear a soft crack in the speaker of the controller and the two orange SIP LEDs start to light up for about 2 seconds. Then the LEDs switch off again and the TRX does not switch on.
I have now checked many things and also changed the cables, but the status remains the same. The following setup situation at the moment:
Radio and control unit are in the same IP subnet on a switch. Both have an IP, both can be operated in the browser. The control unit has the IP of the radio unit as its SIP contact. The controller reports the IP of the radio unit as "other party" in the status.
I have initially set or adopted the default settings for the 7100 everywhere. The jumpers are set according to the instructions and the red cables are plugged into the radio unit. There is a circuit board for the newer version of the IC7100 in the control unit, it is plugged in correctly with the slanted corner at the top right. Both units are connected to the same power supply, which should be sufficiently large at 25A.
I simply have no idea why the system won't start. Who can help me?
73s de Tor
DM1TS
Pages: [1]