1
General discussion forum / Re: Trouble with RC-2000
« on: 2011-11-11, 00:18:06 »
Nevermind, found a cabling problem. Everything is working fine now.
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: [1]
2
General discussion forum / Trouble with RC-2000
« on: 2011-11-10, 15:47:01 »
I am doing the initial setup and test of the RRC-1258MkIIs connecting it to a TS-2000x along with the RC-2000.
The RRC-1258s are both running V2.46 firmware. I have them both hooked together on our local network, connected to the same switch. My problem is, I cannot get the RC-2000 to turn on. When I press the power button on it I get nothing, but if I power on the TS-2000 I get PTT and both recieve and transmit audio to pass through the network, and I also can get Ham Radio Deluxe to work over com2. I followed all of the procedures in the book as far as jumpers and baudrates are concerned. Has anyone else run into this?
Any help would be much appreciated.
Chris Bolton
N0XBD
The RRC-1258s are both running V2.46 firmware. I have them both hooked together on our local network, connected to the same switch. My problem is, I cannot get the RC-2000 to turn on. When I press the power button on it I get nothing, but if I power on the TS-2000 I get PTT and both recieve and transmit audio to pass through the network, and I also can get Ham Radio Deluxe to work over com2. I followed all of the procedures in the book as far as jumpers and baudrates are concerned. Has anyone else run into this?
Any help would be much appreciated.
Chris Bolton
N0XBD
Pages: [1]