YAESU TWIN

[Leo]

Hello!

I do not work with DSP filters work in the twin. FT DX-5000MP transceivers on both sides. I'm better handle width settings, but nothing happens. Wight changed only roofing filters.
What should I do to be able to control the DSP filters?

[Leo]

And more. When you create a virtual COM port via USB I nominate one of the ports on the CW keying. Periodically, the port stops working. I remove the connector from USB computer and back of his stick. After this keying appears. Then again disappears. I had to solder interface on the LPT port and send a signal to the connector I/O. What should I do to avoid problems with the USB ports?

[sm2o]

I hope someone who uses the FT-5000 can answer. We do not have the radios. I have not heard about any problem like that before.

73 de mike

[ON4AOI]

Leo,
make sure WIDTH is ON at the remote side for every band and mode
for some unknown reason this can not not be switched ON/OFF when it wasn't ON b4


Guy ON4AOI

[Leo]

Fine. I'll try.  Function Contur also can not turn on remotely?

[ON4AOI]

Yes Leo there are a few buttons that can not be turned
ON when they never were on b4 on remote rig
strange since afterwards you can switch on and off during a connection


Guy ON4AOI