I am a bit perplexed. I have gotten most things to work. Radio communications, RX audio and CW, but the SSB audio is not working. I have looked at this a few times. I am using the RRC-1258MkIIs with the FTdx5000 on the radio side. I am using just a computer on the control side.
I followed the pictures for the jumpers and they look like they follow the same path as the boards pictured in the manual, The cables I made for the AUX/MIC inputs were made from CAT 5/6 wiring. I was looking at the generic or 2000 pattern. I only hooked up 5-8 (PTT & MIC).
When I am looking at the jumper configuration. The front of the unit is facing me. So Pin 1 is all the way to the right and Pin 8 is to the left on the socket. Since there are only four jumpers, I am guessing that these are the only pins used.
Here is my Jumper Settings:
Back to Front
4 - 5
5 - 8
7 - 7
8 - 4
If I am reading the cable wiring right:
CAT Wiring Side - Radio Side
1 - Orange Stripe
2 - Orange
3 - Green Stripe
4 - Blue - Pin 7
5 - Blue Stripe - Pin 8
6 - Green - Pin 6
7 - Brown Stripe - Pin 6
8 - Brown
The tab is on the top side (like shown in the pictures).
Do I need the rest? All Do I really care about any of the other connections?
Does VOX work remotely?
TNX Will WC2L
