Hi,
I am contemplating purchasing Remote Rig to operate my ICOM IC706mk2 at my other QTH. I am just looking for a basic no frill setup to run SSB, my antenna will be a mutiband dipole so no need for a rotor or antenna switch.
I am planning on modifying the ICOM separation cable and I understand the instruction so that is not a problem. Also I am planning on using the Wifi adapters in both remote and radio units, BUT is it easier to use the LAN port ?? I want this setup as simple as possible
So my concern is once I getting the units working on the remote network at my current location then I move the radio side unit to my other QTH, what changes do I have to make to the remote and radio side units?? is there a "cheat sheet" or any easy instruction ?, I have never done this before and it seems a bit intimidating. If there is some kind of step 1 step 2 etc cheat sheet someone has it would be appreciated. My current location does not allow antennas so hopefully this works out
Need a fool proof setup, QTH's are far apart so impossible to run back and forth.
thanks, Kurt W1WWA
