Icom 7300 and Remoterig

[Mitch]

I have been working my Kenwood 480 for many years now with the RRC-1258MkIIs.

Would like to update the radio to my Icom 7300 would this be supported by Remoterig.

Have looked for post's in the Furum and can't see anyone that has got it to work for them.

73S

[sm2o]

All Icom Radios with a traditional CI-V Interface can be used with Remoterig

73 de mike

[Mitch]

Many Thanks,

Mike just need to try find the link to configuring  jumpers in each box.  I have RS-BA1 Version 2 and Win4IcomSuite would you know if this would work with PC at radio side + control side for the waterfall.

73s de Gary

[sm2o]

The jumpers is only for the mic signal, check the Chapter ICOM IN General.
I doubt any waterfall info is sent over CI-V.

/mike

[Mitch]

Thanks Mike,

Would you know what cable's I need from the Icom 7300 to RRC-1258MkII radio side.

And the cable needed again from the RRC-1258MkII to my laptop at the control side.

73

[Mitch]

Had a look in the Chapter about ICOM IN General. Looking for the correct cables that are needed at Control side and Radio for the Icom-IC 7300.

Has anyone within the group managed to install the 7300 here and can provide cable info needed the run remote.

73's Gary

[G3TKF]

I notice lots of conversations re the 7300 and RR1258

But - has anyone used a pair of IC-7300s successfully together ?

I am enquiring for a friend who has a pair of 7300 one at a holiday home.

73
Robin
G3TKF

[Mitch]

Hi Robin,

Still working the Kenwood 480 did not manage to configure Remoterig with the Icom 7300.

Have even tried Win4IcomSuite + RS-BA1 Version 2 to have both radio's at the Radio side 

Looking for any info to work both radios.

73s Gary