K3/0 problem CAT

[ur5mid]

K3/0 working is well without computer. Any logger do not find com-ports. I tried via virtual port or to direct COM1.But no results.
PS: COM1 ( COM4)
COM2 ( COM7)

control panel serial number 2511
radio control serial number 2600
software 2.72

Serial settingsCOM1 mode    3
COM1 baudrate    1200
COM1 data bits    8
COM1 stop bits   1
COM1 parity   off
COM1 rts/cts    yes
COM1 terminator (hex)   
Use USB Com Port as COM1 yes   
    
COM2 mode    logical parallel with com0   

COM2 baudrate    9600
COM2 data bits    8
COM2 stop bits    1
COM2 parity    off
COM2 terminator (hex)   o
Use USB Com Port as COM2 no   
    
COM3 mode (USB-COMFSK)







Radio settings 14   
Sip password   
Sip contact   
Auto connect    No
Audio quality    2
Codec out gain   255
Codec inp gain   18
Codec inp HPF Hz    327
Codec inp preamp yes   
COM0 baudrate    9600
COM0 data bits    2
COM0 stop bits    off
COM0 parity   2
COM0 Program mode 3 char timeout   
Use USB Com Port as COM0   no   

[dj0qn]

I assume that you are using the K3 Twin mode, since you didn't make that clear.

If so, here is how you get CAT working:

- Go to the serial settings on the radio RRC and change COM1 to "Mode-7, CAT to COM2". Make the rate the same as COM2.
- Go to the serial settings on the control RRC and do exactly the same
- While on that page, change "Use USB COM port to USB" to YES if you want to use the virtual serial port, otherwise connect
   a serial cable to COM1 on the control RRC (but watch out - the pinout is backwards from normal!)

73,
Mitch DJ0QN / K7DX

[ur5mid]

I will try to install tomorrow.
But i want using COM1  for rotator.
COM0, COM1,COM 2 only for CAT???
it`s stangely

[dj0qn]

That is unfortunately how it is. On a normal RemoteRig configuration, you would use
COM2 for CAT and COM1 for something else, such as the rotor.

However, the "Twin" configuration (Elecraft & Yaesu) use COM2 to communicate
between the two RRC's and therefore block this port. So the only way to get CAT
on the remote end is to use a mode that combines COM1 and COM2 and use
COM1 for CAT.

You will therefore have to find another solution for your rotor, such as a serial
server or Webswitch.

73,
Mitch DJ0QN / K7DX

[ur5mid]

I installed COM1 to mode 7. it`s work very well.
But i have new problem. After 15 minutes, the connect disappeared. The control panel shows the message "IP error." I do not know why. Installation did not change, except for COM1.

[ur5mid]

now ok