Easy Rotator Control

[hb9edm]

Hi!

This post just to inform how to connect the ERC on the COM2

- The Expert 1k use the configuration written on the "Power Amp/rotators" section. It use the COM1

- The ERC (rotator control with yaesu G1000 DXC) use this configuration (COM2):

mode                        3 - char timeout
COM2 baudrate             4800
COM2 data bits              8
COM2 stop bits              1
COM2 parity              0-off
COM2 terminator (hex)   0d

ERC-cable at the radio site, straight cable at the control site (thsk HB9AZT)

I hope that this post can help.


best 73

hb9edm


P.S the ERC interface is very good, the support is fantastic! thks Rene

[sm2o]

Hi

I do not understand what the problem is ?

TS-480 OK via COM0, expert OK via COM1 , rotor OK via COM2.

I don't think the life can be much better.

73 de mike

[hb9edm]

Hi Mike!

absolutely no problem! All is working fine.

My post was just an information for the connection with the ERC (Easy Rotator Control) and the remoterig via COM2.

I change the thread.

[SA0IAT]

Happy to find your post. Just received my ERC-kit, and hope to have it assembled soon...

Just one question; at the radio site you say you use the ERC-cable. But the d-sub of ERC is female, and so is the d-sub of RRC? Do you use a null modem male-male adapter? Or a straight male-male adapter?

Of course you could just change the d-sub of ERC-cable to a male one (with same pins connected?), but in this case I would need a female-female adapter every time I connect my computer at the radio QTH 

[hb9edm]

Hi!

On the remoterig the com2 is male. The cable used from the ERC and the remoterig is jack to rs232 female.

No adapter.

Best 73
HB9EDM

[SA0IAT]

Oups, missed that (only having the controller RRC here at the moment) 

Thanks again for the configuration info!

[SA0IAT]

I have some odd trouble after installing the ERC at my radiosite today. On location all worked perfect.

But via RRC from home-QTH I donīt get any readings in the ERC Control from the rotor. However in ERC servicetool, when pressing "read", I get the present antenna heading under "status".

Any ideas?

Iīm using the same computer, the same installation as I did on the radio-QTH so it should not be a software issue...

[hb9edm]

Hi!

strange problem.
ERC is used with which rotator?

Port settings are corrected?

Eventually you can try with other software like hrd rotator.

[SA0IAT]

Using it with Yeasu G-1000DXA. The strange thing is that it worked 100% on location....

Serial settings in RRC exactly according to your post above.

Will mail Rene and see if he can give me a clue.

[SA0IAT]

Finally fixed it, however I needed to use com1 instead, and made a null-modem on the radioside. Rene sent me this link http://easy-rotor-control.dk/html/erc_with_remoterig.html - maybe useful for someone else...

Really canīt see the difference from com2, but most important is that it now works