Some additions that can be changed if all is runing ok like Mike wrote.
2. set the TS-480 com port to 9600 baud
Maximum that it works ok here is 38400baud
3.set up the Radio-RRC Com2 to Kenwood prot, 9600 baud etc.
If 2 is changed to 38400 also change this one.
4.set the Micro RRC Com 2 also to Kenwood prot, chose one of the virtual comports
This should be the last virtual comport in your list, (com2)
"Mike can change the driver so that we can assign/change the comport-number pse
when installing now it assigns portnumbers that never have been used b4,
even when they are not in use or attached anymore, mine are 9-13 and 14 and some programs still dont
work above comport8.
5. set HRD to TS-480, Chose the same comport as above and set 9600 baud
If 2 is changed to 38400 also change this one
depending on the cable you made RTS and CTS need to checked in HRD when there is no-short
between pin7-8 at the tranceiver comport
6 NEW in the RRC Radio side set in radio settings AUDIO QUALITY to 0 alaw(alow) 8 kHz
sometimes in HRD you don't get audio at start
just slide the AF to max and it start working ok
after that you set it lower again
73 Guy ON4AOI
