Hi All,
having said that :
- I've got both FSK and CW working with 2.41
- did no hardware/cabling/software mods on both Radio & Control site
after upgrading both RRC's to 2.46 and SetupManager to 1.12, neither CW nor FSK worked.
CW was easily fixed, enabling "PTT activated by Keyer" on RRC Radio
On FSK, I had PTT keying the TS-480 ok, but only a continuous tone coming out
I read the manual carefully
I re-checked the MMTTY settings in order to eliminate all EXTFSK references
I read the manual more carefully
No way .. PTT was keying, but always a fixed tone came out.. ( yes, I was monitoring my HF signal, not the speaker
)
To make a long story (night) short, I got it finally working, switching OUT2 on "Baudot/Inv" instead of OUT1 (see my previous post
http://www.remoterig.com/forum/index.php?topic=819.msg3973#msg3973 )
Sure I'm using Pin3 on Radio I/O , as before
I read the manual more more carefully
from the V2.41 User Manual :
Radio RRC /I/O connector:
Pin no
I/O (RJ45)
1 IN1, active low (CW-Keyer right-paddle)
2 IN2, active low (CW-Keyer left-paddle)
3 OUT1, open collector
4 IN0, active low (only available at Control-RRC)
5 OUT0 open collector
6 OUT2 open collector
7 8V OUT (max 100mA)
8 GND
I read the NEW (Release A16 2011-nov-01) manual
Pin no
I/O (RJ45)
1 IN1, active low (CW-Keyer right-paddle)
2 IN2, active low (CW-Keyer left-paddle)
3 OUT2, open collector (parallell with PAD Tip at Radio-RRC)
4 IN0, active low (only available at Control-RRC)
5 OUT0 open collector
6 OUT1 open collector (parallell with PAD Ring at Radio-RRC)
7 8V OUT (max 100mA)
8 GND
Clear now, OUT1 and OUT2 swapped ...
(come on guys ... it was 3:00AM
)
So, READ the NEW manual CAREFULLY !
I particularly appreciate the new RTS keying function. Before I had troubles, as "PTT via Radio command" often didn't work.
Thanks ! My whishlist is empty
Gianni IN3ASW
