Loss of CAT Control

[ei6al]

Have had to replace the remote RCC due to lightning strike.  New unit was V 2.66 so upgraded local unit firmware from 2.41 to 2.66.  Changed Remote ports to match local ports Cmd 1200 Audio 1100 SIP 5060.  Control then worked fine.  However, cannot get Com1 (Expert Amp) or Com2 (CAT TS480) to work, using exactly same configuration that had previously been used before firmware upgrades.  Is there a change to configuration on these ports that needs doing, or am I missing something obvious?

[ON4AOI]

Try to reboot both devices and check if everything still match your
settings


Guy ON4AOI

[ei6al]

Tried that Guy - everything remains as before, all settings look fine.

[ei6al]

My last reply wasnt too clear Guy - settings remained unchanged after reboot, but I still have no function on either RS232 port.  As last resort am considering reload of original firmware but concerned about doing that as remote site is 250km away and if anything goes wrong its a long drive.  So if there are any ideas as to why I have no functionality on com1 or com2 would appreciate hearing them.

[sm2o]

There is no changes done in the firmware concerning com1 and com2, check the settings or send me the the exported settings html. Downgrade to old firmware will not help

73 de mike