TS710G

[London Radio Service]

I have purchased (3) 1258MKiiS kits, will be using them on the Kenwood 480SAT and 710G.
The 480 interface went good, all seems to working however I have not been able to get
the 710G to power up.

I have double checked and even made more interface cable for both ends,
I have even tried the second set of 1258s but I still cannot get the
710 to power up remotely. I have used the factory cable to and connected the
control back to the radio all works fine... just no remote control.
triple checked the config of both sets of 1258 with no avail..
any thoughts where to go next?
My phone is 606-878-8012, Kentucky, thanks

[sm2o]

email us the exported settings (html) files from both units

/mike

[London Radio Service]

Thanks Mike,
I guess I timed out and didn't realize it...
Attached are the HTML files,
I have (1) TS480 which power up just fine but we have not tested anything else...
I have (2) TS710 which will not communicate or something to each other, will not power up.. I have compared the setup to the
480 but nothing jumps off the page. Both units work fine when direct connected to each other.
I have made the cables twice unless I'm missing something in the config instructions just downloaded from your site.
These are all new units, just arrived within the last week

All (3) units are on the same network, closed, not going to the outside world.
This is a public safety 911 center in their RACES room.
Thanks for any support on this and any other suggestions for a successful installation.

[London Radio Service]

Attempt to attached the HTML file

[dj0qn]

You are using exactly the same ports for both sets, which will not work. You must change all
three ports to something completely different, e.g. 13003, 13004 & 13005 or similar.

These new ports must be forwarded to the second internal IP number, which is different from the
first setup.

73,
Mitch DJ0QN / K7DX