Hi,
I have an RRC-1258 mkIIs v7 Control Side that seems to no longer be able to speak Ethernet.
Looking at the serial port, I see the following message when it boots:
==========================================
** 1258 Bootloader V1.14 **
** CPU type: 2387 **
** 0114
** Booting application **
==========================================
** Press capital x for xmodem apploader **
==========================================
Company : Microbit
Product : 1258
Version : 7
HW : 8
Software : 2.95
Bootloader: 1.14
Compiler : 4.6.2
Build : May 4 2019 08:32:26
ROM/RAM : 488400/44304
ethRAM : 3000 (max 3kB)
USBRAM : 16376 (max 16kB)
BatteryRAM: 4
ResetSrc : 4 [3]
Uptime : 0 Days, 0 Hours, 0 Mins, 0 Secs
=========================
HW-device = 0
CW-pot = 212
Debug level = 0
Control panel = 1
Program mode = 4 - Yaesu, Kenwood, Elecraft
PID = 4
Setup length = 1265
=========================
enable : 1
speedWpm : 0
iambic : 1
paddleReverse: 0
weight : 30
sideToneHz : 800
sideToneDb : 20
lfDelayMs : 0
keyDelayMs : 50
codec = WM8985
silDetSet: 0 90
audio = BOTH_OPEN
duplex: New Audiocoding 102 (8 KHz)
ENET_REF_CLK not running, skipping ethernet init.
Ethernet link timeout, activating Wi-Fi
On a working unit, I do not see the 'ENT_REF_CLK not running' message. Looking at the PHY package, it seems a bit on the tiny side to replace even with a rework station. Is it possible to get a replacement PCB? Any other suggestions as to what can be wrong?
73,
Bill/W9KKN
