Remote Rig

RRC 1258 Support in English => Configuration, RRC 1258 => Topic started by: VK3EQ on 2012-11-18, 01:13:04

Title: RRC-1258 radio rets to Contoller IP address
Post by: VK3EQ on 2012-11-18, 01:13:04

Has anyone experienced a problem with the RRC radio I/F resetting to the Controller IP address (192.168.0.227) after a master reset (held down for 30sec) and then being seen by the setup program as a controller not a radio. Have the same problem with my two RRC Radio I/Fs. I have the latest version of SW loaded on all I/Fs

Rik VK3KAN

Title: Re: RRC-1258 radio rets to Contoller IP address
Post by: n0ary on 2012-11-18, 02:23:20

I saw this exact same problem today after loading 2.65 in both units. Now both report as being Control, both have the field for setting Sip Contact, and they no longer will connect to each other.

By downgrading to 2.55, what I originally had, the radio side is now identifying as  a radio and things are working normally.

Title: Re: RRC-1258 radio rets to Contoller IP address
Post by: sm2o on 2012-11-18, 10:41:02

Hi

I have sent you instructions by e-mail about how to solve this situation, it's very simple

73 de mike

Title: Re: RRC-1258 radio rets to Contoller IP address
Post by: VK3EQ on 2012-11-19, 23:10:47

Mike

Unfortunately I have an ISP problem at the mement, could you please send the details to the alternate email I sent to you. Also are the details somewhere on the web site or in the forum. It might be helpful for others to be able to resolve this issue

Rik VK3KAN

Title: Re: RRC-1258 radio rets to Contoller IP address
Post by: VP8ALJ on 2013-02-02, 11:40:45

Hi Mike.

I have the same problem with the RRC radio I/F resetting to the Controller IP address (192.168.0.227) after a master reset and then being seen by the setup program as a controller not a radio. I loaded the latest version of SW on the two units and the problem persist.

Help please!!!

Mario VP8ALJ.

Title: Re: RRC-1258 radio rets to Contoller IP address
Post by: sm2o on 2013-02-02, 12:54:17

Note! Sometimes when upgrading an older versionen to v2.65 or 2.66  the radio unit change config to look like a Control unit

It's very simple to solve

http://www.remoterig.com/wp/?page_id=1695