Messages

1

General discussion forum / RC-1216H - SteppIr SD 100 - Firmware 4.4 up - lost serial settings

« on: 2015-04-17, 22:25:56 »

Hello all,

last weekend I updated all my remoterig components with the newest firmware. Works fine, only trouble with RC-1216h 2.8v  to 4.16v. I lost the connetion between SteppIR Controler and SDA 100. Missed seriall settings: "No settings available for this device".  Downgrade to 2.8 and try higher version step by step, find serial settings only until Firmware version 4.0.
Need higher version no serial settings ?
At the moment RC-1216h with SteppIR works fine with V4.0 ...

73 de DJ3NG 

   

2

General discussion / Win7 Home Premium 64bit

« on: 2013-02-11, 21:58:18 »

Seem to be the same problem. After update to 1.63 I donīt have virtual comports... What shall I do ...  ? 

DJ3NG, Sigi


After hourīs :
Problem solved manually !
 

3

General discussion forum / Re: Yaesu Twin with 2 FT-950 - Radio turns off

« on: 2012-09-25, 19:40:57 »

Mike tnx , Audio quality was "alaw 8 kHz". Bandwidth is LTE 3600, hope to get more in a few month.... !

73 de DJ3NG

4

General discussion forum / Yaesu Twin with 2 FT-950 - Radio turns off

« on: 2012-09-24, 08:51:41 »

Hi all,

Yaesu Twin with two FT-950 works fine with one exception: If I change in search mode to quickly the frequency, the remoted radio turns off. When I turn on und off after a few seconds the control radio, all works fine again. The same happens with PC-Client and Software like HRD or PCC-950. The speed of the serial port is 38.400 Bd, I have tested 19200, 9600, 4800 - with the same result. Any idea ?

73 de Sigi,DJ3NG   

5

General discussion forum / Re: Expert 2K-FA

« on: 2012-09-22, 22:25:06 »

Hi,
only for complement,
the Expert 2k-FA 9-pin should be for remote control and connection to the SteppIR controller. But the port does only 115.200 bd.... Good for my  RS-232 server and remote control,  but to fast for the SteppIR-Controller SDA 100 .... he can only 57.600 ! 

73 de Sigi, DJ3NG
     

6

General discussion forum / Re: Expert 2K-FA

« on: 2012-09-04, 17:18:26 »

Hi,
the Expert 2K-FA (new series)  have a 9-pin port - calling "port" to connect to the pc-comport or comport-server and to the SteppIR controller SDA 100. With the trivial software from SPE "Term_2k_232" you can remote the PA. I have  it tested today - in my home Network and over the I-Net.

73 de Sigi, DJ3NG