Messages

1

General discussion forum / Re: Can there be an APP to decode/encode UDP audio on a PC and Rx/Tx to 1258

« on: 2014-05-26, 17:14:47 »

Thanks Mich,


Gary

2

General discussion forum / Re: IC-7100 locks up on HF

« on: 2014-05-25, 01:39:09 »

I would really look at your ground system,  make sure you have a short run to earth and have one central point for all equipment, preferably by your tuner.

Had this problem and finally drilled a hole in floor under bench and drove a ground rod.  Problems went away.  Know this is drastic but if I ever move I will drive to flush and patch.

Good luck

Kt7az

3

General discussion forum / Can there be an APP to decode/encode UDP audio on a PC and Rx/Tx to 1258

« on: 2014-05-24, 22:59:55 »

I was wondering if it would be possible to connect to RR1258 and decode UDP and listen to audio on your PC.  One step further would be to enable PTT and pass Tx audio via PC sound card.
Would really be a great iPad app also.

Tnx

Gary
Kt7AZ

4

General discussion forum / Re: WiFi Option in US

« on: 2012-10-13, 05:04:09 »

I ordered direct from Remoterig and got it in a week.  Works great.
You need to add the SSID and passphrase manually after the scan in setup program.  Kind of a pain but once you do it for a particular WIFI spot it remembers.

KT7AZ
Gary

5

General discussion forum / Re: control unit locks up when powering it on.

« on: 2012-09-02, 22:30:14 »

I have a brand new Remote Head unit s/n 5022.  I have found pretty much the same problem as first post.

red and yellow light stay on and no conncetivity when powered by 12v power cube.
(I have tried a couple of cubes with 2 amp spec)
My unit is consistent with this issue.

The Work Around is -- If you unplug all power and then plug USB in first it will boot and go to green blink light.  If you then plug in 12v power cube, green light will go steady and all will work properly.  YOu can then unplug USB cable and all will be fine (until next power cycle)

I also noticed you can do a restart through web page and unit will reboot properly.  It appears to only fail when power is completely removed and rebooted.

I have the latest firmware build Aug 15 2012 15:15:57, software 2.61.

Please let me know if you have any other ideas.

Thanks,

Gary KT7AZ