Messages

1

General discussion forum / Re: Power failure?

« on: 2013-07-01, 16:44:24 »

Hi!

Thanks for the tips. When it boot, its runs perfectly. So now I have connected it to a 24 hour sypply.

Jag sender min RRC til er i Augusti, det går bra. Så får vi den 100% igen.


73 de LA6MNA-Leif.

2

General discussion forum / Re: Power failure?

« on: 2013-06-27, 18:11:21 »

Hello Mike!

Thanks for answer! I have tried to do as you wrote, but it is the same. But I have some new info. When running on only USB power, it boots up and I can use Microbit setup manager and all seems to be ok. The green power led is now flashing. So I connent the 12V to the RCC and the green power led stops flashing after a while (5-10 sec.) Then I disconnent the USB power and RCC is up and running. Now works again. If I now again disconnect 12 V from RCC, It will not boot when I again connect the 12V.

Any Idea? Or must I send it to you?

73, LA6MNA-Leif

3

General discussion forum / Power failure?

« on: 2013-06-27, 16:45:34 »

My RRC-1258 MkII (Dispaly side) has ceased functioning. When I connect the 12V to the RRC, I only get red and Yellow led's lit. The PWR LED remains unlit. I turn of power yesterday, an then all were functioning. I had only once same problem 2 days ago, but then I turn on and of the 12V power, and all was okay. I use the RCC for IC-706 MK2G. It is also impossible to reach the box from the computer through Microbit Setup Manager og via Ethernet port. Any suggestions what to do, to get it to work again?

73, de LA6MNA-Leif