Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - kc2ky

Pages: [1]
1
I have a 706 mkii integrated using the separation cable / RJ45 splice method.  It works fine for 10 or 15 minutes.  Then TX audio starts to get distorted, and eventually the rig powers itself off mid-QSO.  This occurs on 2M FM, with  RF output power set to about 1 watt.  After turning the rig back on it works for another 10 or 15 minutes.  I don't notice the problem on HF but I don't tend to have long rag chews on HF and most of my HF activity is CW.  Radio and radio-side RRC box are running from a 35-amp Astron power supply in the radio room downstairs. Control-side RRC and 706 control head are on a 3-amp Radio Shack power supply next to the living room couch. Data link is via wi-fi.

Has anyone seen this on an IC706 or on any other rig for that matter?

73

Neil

2
Has anyone been successful at setting up the radio side from a router getting its internet access from optimum online?  I can't seem to get into the radio controller from the outside.

Thanks in advance

Neil, KC2KY

Pages: [1]