Messages

1

Configuration, RRC 1258 / Re: Recent N1MM+/Winkey Emulation Problems

« on: 2016-03-30, 15:05:36 »

Mike,

I am experiencing the same issues with K3 and RRC control unit. My cw was fine until about 1 week ago and then when I pushed F4 key, for example, I got a staccato msg for my call W4YY after 3 or 4 pushes, it would send fine but then same would happen again soon thereafter.

I upgraded to V2.90 yesterday, checked all my keyer settings, etc and nothing had changed.

What responses, if any, did you get and/or how did you fix this issue?

Tnx y 73
Tom
now HP1AC

2

Configuration, RRC 1258 / Re: K3/RRC1258 not connecting radio to N1MM+?

« on: 2015-05-29, 01:50:48 »

Not sure what you mean about enable the USB port in the RRC as I have been using that port to config the Setup manager as per the instructions that came with the Elecraft K3 Remote Owner's manual. If I can change the parameters in the Setup manager with this same cable, does this not mean that the port is 'enabled'.

73
Tom

3

Configuration, RRC 1258 / K3/RRC1258 not connecting radio to N1MM+?

« on: 2015-05-27, 23:03:08 »

K3 will not connect to N1MM+ through RRC1258 MkII.  Device manager sees: Com0 (Com7); Com1 (Com6); Com2 (Com8); and ComExtra(Com5). Using the example in N1MM+ documentation of 38400, N,8,1 and DTR/RTS Always Off.  K3 menu is set for 38400.  Msg pops up and sez, "Radio #1 (manual) on Com7 is not responding. Restore the connection and click Retry below......).

I have tried using Com6, N,8,2, DTR/RTS Always On and DTR/RTS ON/OFF and Handshake...cannot get radio to connect with N1mm+. Have also changed port settings in Device manager from 9600 to 38400; still no connect.

Am using the supplied USB/mini plug that Elecraft sent with the control unit.

 Window 8.1 OS.

Help or suggestions?

73
Tom

4

Configuration, RRC 1258 / Re: How to reset password on K3 Twin 1258 MkII

« on: 2015-05-27, 22:45:57 »

Tnx Ian,

I never did find that part in the RRC manual about the reset; however a friend suggested I hold the RES button until it did reset...I had been doing about 5 sec with no changes. In frustration, I held it (actually SMASHED) for 25-30 sec and that worked fine.

Now I dont need username/PW. Now on to other issues....

73
Tom

5

Configuration, RRC 1258 / How to reset password on K3 Twin 1258 MkII

« on: 2015-05-23, 23:44:55 »

Unable to utilize Setup manager as each selection (other than Info) asks for Username and password.  I had tried setting up the system a month ago and must have set a password but can not remember what it was.  How can I reset?
I tried changing the IP addresses but that did not matter nor did uninstalling and doing a fresh install for Setup manager. 

When I click on any button, such as Radio settings, it says:"The server 192.168.1.169 is asking for your username and password. The server reports it is from Remote Rig."

Suggestions (other than better memory or writing it down!)??

73
Tom