Show Posts
1
General discussion forum / Re: PCC-2000 to control FT-2000 via RRC 1258MkII - any positive results?
« on: 2010-04-25, 10:24:47 »
Dear Marco & Mikhail,
Many thanks for your kind replays, I would like to search the possibility to use the following configuration: FT2000 rig + PCC-2000 (full control of FT-2000 remotely) + HamRadioDeluxe (for logging & spots / tuning by spot) + SteppIR (3el) + Yaesu G800DXA. To use just only internal options of RRC 1258MkII.
Well, now I see the folowing solution: SteppIR will be connected via Y-cable directly to RIG and will tune automaticaly after HRD / PCC freq change, G800DXA - connected directly to RIG (rotate port with PS/2 cable, and might be controlled from PCC-2000), PCC-2000 and HRD might use the COM1 (CAT FT2000 option) sharing it with use of free Virtual Serial Port Emulator ( http://www.eterlogic.com/Products.VSPE.html - TNX Marco for info!)
So, there is still COM2 is free for other options (PA, etc.)
Mni TNX for support and info!
Mikhail, I will call you a bit later, TNX for your attention.
73, Andy RZ3EM
Many thanks for your kind replays, I would like to search the possibility to use the following configuration: FT2000 rig + PCC-2000 (full control of FT-2000 remotely) + HamRadioDeluxe (for logging & spots / tuning by spot) + SteppIR (3el) + Yaesu G800DXA. To use just only internal options of RRC 1258MkII.
Well, now I see the folowing solution: SteppIR will be connected via Y-cable directly to RIG and will tune automaticaly after HRD / PCC freq change, G800DXA - connected directly to RIG (rotate port with PS/2 cable, and might be controlled from PCC-2000), PCC-2000 and HRD might use the COM1 (CAT FT2000 option) sharing it with use of free Virtual Serial Port Emulator ( http://www.eterlogic.com/Products.VSPE.html - TNX Marco for info!)
So, there is still COM2 is free for other options (PA, etc.)
Mni TNX for support and info!
Mikhail, I will call you a bit later, TNX for your attention.
73, Andy RZ3EM