Messages

1

Configuration, RRC 1258 / Re: RRC Control unit not found using Microbit Setup Manager

« on: 2017-11-22, 23:12:28 »

Mitch, please send the checklist. But what is the dynamic DNS address? I'm using the  DNS address found on my home (remote site) computer.

Thanks.

Art

2

Configuration, RRC 1258 / RRC Control unit not found using Microbit Setup Manager

« on: 2017-11-22, 21:39:25 »

Got both units communicating and operating as expected with K-3 Twins on home LAN. Now that I'm away and attempting to connect, I am unable to connect. So I tried connecting the Control unit directly to my pc. When I open Microbit Setup, the message is "device disconnected." Tried selecting Net Info/Find.Message does show the device with the IP I have set for it, with the statement after it "Not reachable." I can select "config" but it shows settings that I did not setup. So I enter the IP, Gateway, DNS and hit SAVE. Then I reboot as directed, and once3 again the same message appears showing the device with IP I set but NOT REACHABLE. But, the new settings do not end up being saved when I click on the config tab to check.


Any suggestions would be appreciated.

3

Configuration, RRC 1258 / Re: Can not connect-device manager shows no virtual ports installed

« on: 2017-11-19, 17:40:12 »

Mitch, as always, you are a brilliant resource. The issue has been corrected. I used the router's IP at first. Once I entered the correct IP in the SIP, connected as expected. Thank you so much!

73,

Art KZ5D

4

Configuration, RRC 1258 / Can not connect-device manager shows no virtual ports installed

« on: 2017-11-19, 16:19:53 »

I cannot connect the K3/0 to remote K-3 over my LAN. Device manager shows NO serial ports installed. Both RRC units have been setup correctly and are showing connectivity to the router.

5

General discussion forum / Re: RRC dropping out frequently after working flawlessly for several days

« on: 2016-03-10, 01:01:47 »

Mike,
All worked fine for the last 4 days. No dropouts. Today it is much different. Seems the IP at the remote site is having trouble. Hopefully that is the problem. Thank you for your input.

73,

Art KZ5D

6

General discussion forum / RRC dropping out frequently after working flawlessly for several days

« on: 2016-03-09, 18:10:05 »

Using K-3/0 mini at control site with RRC1258 MkII. Good hi speed internet connection here and at remote site (home). Have the RRC 1258 MkII connected to K-3 at home. Audio drops out for a second or two and then returns. Is there a setting I need to adjust? Also noticing very short drop outs indicated by what sounds like a very short burst of static-similar to a loose connection.

Would appreciate any suggestions.