Messages

1

Hardware, Cabling, Installations / Re: humidity sensor compatibility?

« on: 2019-11-10, 19:32:44 »

That link given above is a bit pricey (50 €), don't you have any cheaper humidity sensor reference that has compatibility with the Webswitch?

Regards Nicolas F1RAF

2

Configuration, Webswitch 1216H / Re: Yaesu rotor calibration not work

« on: 2018-05-04, 07:54:31 »

I have a G-2800 DXC connected to RC1216 via an ERC4 serial interface. I have made the rotator calibration in the ERC interface (a software is provided by ERC) , not in RC1216 which just send RS232 to ethernet and manage 2 relays... I do not know the G232S-b device, but it should be able to calibrate your rotator.

73 Nicolas F1RAF

3

General discussion forum / Expert 1.3K / RC-1216H / and SPE kterm_1.3_232 software

« on: 2018-02-10, 11:44:42 »

Hi there,

I have been using successfully the 1.3K (last firmware october 2017) remote control with RC-1216H (firmware 4.27) displaying on a webpage. This is quite easy to use, works very well but does not permit all functions such as the ATU control. To be able to use the "Tune" function, I have set the SPE software (kterm) and followed the remote ring instruction to create a serial port. Eventually it work, when I connect, the web windows of remote rig displays "remoted" and I have 2 windows from kterm software (one that displays power and SWR, the other one for functions (including "Tune"). The problem I am facing is that that software is very slow, when I hit a function, I have to wait for 2 minutes before it is confirmed by display. I initially had set the connexion at max speed (115.000). I tried at other speed, ands it does not change anything. Is it a known bug ? This is not an internet issue since all other remote devices (transceiver, rotator aso work very well, including SPE 1.3K when I use the remote rig window). Is it a known issue, what can be done? I have the last version of all firmwares and SPE software. My windows OS is Windows 7.