Messages

1

General discussion forum / Re: New installation: "Popping audio", jittering, frequent radio resets

« on: 2019-09-03, 04:12:52 »

I hooked up the unit at home and, as you might have expected, *almost* no popping or dropouts. Using PingPlotter, I see a bad hop, so I'm not sure what to do about it, but I will be researching it.

Allen N5XZ

2

General discussion forum / Re: New installation: "Popping audio", jittering, frequent radio resets

« on: 2019-08-27, 05:18:28 »

I haven't had a chance to try it at another location yet. I'll let you know.

Allen N5XZ

3

General discussion forum / Re: New installation: "Popping audio", jittering, frequent radio resets

« on: 2019-08-21, 03:21:32 »

Mitch, I tried your suggestions and they made a slight improvement but not enough to make the connection smooth. Any other suggestions?

Allen N5XZ

4

General discussion forum / Re: New installation: "Popping audio", jittering, frequent radio resets

« on: 2019-08-15, 16:05:44 »

Thanks, Mitch. I shall try your suggestions and report back.

Allen N5XZ

5

General discussion forum / New installation: "Popping audio", jittering, frequent radio resets

« on: 2019-08-15, 15:33:29 »

I have a new K3/0 & RRC1258 MkII setup to a remote K3. First time user. I get alot of "popping" noise, intermittent loss of audio and frequent need for radio resets. Not sure what I should do to try to mitigate the problems. Operating from an apartment, AT&T 100 mBit connection. I tried adjusting Rx jitter buffer size and Rx jitter delay but that had little effect. Suggestions?

Allen N5XZ