Messages

1

General discussion forum / Re: Solo Portadora sin Audio de repente??

« on: 2020-06-12, 23:43:40 »

Yo sigo sin audio en ptt, cajas mandadas al servicio técnico, No se donde estará el problema ?Todas las comprobación echas e incluso con otro servidor Remoto

2

General discussion forum / Re: Solo Portadora sin Audio de repente??

« on: 2020-06-10, 18:03:33 »

Varias pruebas echas con diferentes cables,
- emisora probada en su mueble original y con audio
-comprobación de conexiones de cajas
-reset en emisora
- comprobación de puertos
No hay audio en ptt alguna aportación? Gracias

3

General discussion forum / Re: Audio Problems

« on: 2020-06-10, 12:16:55 »

Tengo el mismo problema que este compañero y e echo las mismas  comprobaciones y sigo sin audio en portadora

4

General discussion forum / Solo Portadora sin Audio de repente??

« on: 2020-06-10, 11:40:58 »

Funcionando bien de repente solo Portadora sin audio. Solo portadora. Que a podido pasar yo no e tocado nada y de repente solo portadora Sin voz. En algunas bandas nisiquiera portadora.

5

General discussion forum / Re: TS-480 Freezes..

« on: 2020-06-05, 22:40:21 »

You will need to do a lot of testing to figure out the problem. Use the process of elimination to
determine what the problem is not and go from there.

I first suggest that you move the control RRC to another location and see if the problem occurs. It
may be at the control location and not at the radio location. Once you have determined which side
it is on, then you need to see what is causing the problem.

Look at the RRC's status page to see if there is an error message when the problem occurs. Sometimes
this will tell you which port is causing the problem. Changing that port may solve the problem.

Often it is a bad router or other devices in the network that are causing the problem. Only by using
the process of elimination and first taking all possible problem causes out of the equation will allow
you to narrow down where the problem is.

The only thing I can tell you for sure is that you are looking at the wrong culprit; the problem is with your
network and not with your RRC or its settings. These settings will allow you to partially compensate for a bad
network connection, but they will never solve them.

Good luck and let us know how you are doing.

73,
Mitch DJ0QN / K7DX

Hola buenas noches, tengo el mismo problema que tu, se me queda la Kenwood 480 bloqueada y no puedo mover ningún botón y algunas veces se conjela la señal. Me podrías decir que modificación as echo en el router ??  Cuando me pasa este problema se me enciende una luz Roja en la.caja. gracias

6

Configuration of Routers, Firewalls, etc / Re: ISP uses Carrier-grade NAT (CGN)

« on: 2020-05-30, 19:29:55 »

thanks for replying, the router is tp-LINK Archer MR600. I think my mistake is in the Vodafone Spain telephone company that uses cg-nat.

7

Configuration of Routers, Firewalls, etc / ISP uses Carrier-grade NAT (CGN)

« on: 2020-05-30, 19:02:11 »

Hello, I have this problem when I berify this function in my 4G router. It doesn't let me control the ports or configure anything. What I can do ?    http://www.remoterig.com/wp/?page_id=3494