Messages

1

Configuration, RRC 1258 / Settings for Winkey use only?

« on: 2024-08-13, 23:04:06 »

Hi

I am using a pair of RR units to key a Flex 6600 at my remote site. Since I am using Flex's own SmartSDR software for radio control and audio, I am only using the RR units for CW.

What settings to do I need to change in the RRs to reduce their bandwidth consumption to the absolute minimum to support CW only?

I don't need the audio transfer or radio control so I would like to disable them if possible.

Thanks
John G4IRN

2

General discussion forum / Re: RRC Units for CW and Audio Only - No radio

« on: 2023-09-18, 11:00:00 »

Thanks Mike, I tried this out and it works fine.
73 John G4IRN

3

General discussion forum / RRC Units for CW and Audio Only - No radio

« on: 2023-09-13, 09:17:45 »

Apologies if this has been covered previously but I couldn't find anything on the support forum.

Is it possible to use a pair of RRC-1258MkII units to transfer CW and audio over a remote connection without actually having a radio connected?

So for example, if I had a remote Flex radio and wanted to overcome the CW and audio latency issues by using RRCs but am happy to control the radio through SmartSDR - would this work?

I tried settng the Radio's Program Mode to 'Transparent' and the COM ports to 'Inactive' but the units don't seem to do what I was hoping for.

Thanks
John G4IRN