Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - 4Z4OQ

Pages: [1] 2 3 ... 7
1
General discussion forum / Re: RRC dont communicate
« on: 2023-08-25, 23:00:44 »
So with Mike's help some IP setting had to be change and all works fine.
getting his support during weekend (Friday night) is not common and much appreciated.

Thanks again Mike

73
Ziv 4Z4OQ

2
General discussion forum / RRC dont communicate
« on: 2023-08-25, 15:08:35 »
Hi
I have RRC for several years all works great. Radio is ts-480 and connection via DYNDNS
I was away from radio for 2weeks and return home today panel don’t light-up and get the 3tones bips 
Remote RRC:
Green light flashing.
Yellow light on Auxmic flashing.
I can access the RRC via lan in the correct internal address

Radio RRC
Can assess from home to the RRC on the correct port
Reset the rrc didn’t help
Radio   ON
Connection status   Disconnected
SIP status   Idle
Last SIP error   None
 
What else to look for?

3
General discussion forum / TS-480 RRC LOST CAT
« on: 2023-01-03, 09:03:25 »
Hi
I am using ts-480  & RRC for about 10 years and all working great. Yesterday night worked many FT8 stations without any problems. This morning I CAN NOT control the Radion via the software.
My Setup:
TS-480 (4800 baud)
USB to com port (4800)
JTDX  software (4800).
Radio in SSB & CW works fine
Ping the remote side 22ms
I can connect the router in the remote side without issue. (port8080)
However, connecting to RRC in the remote side (radio) via port 80 I am getting huge delay until the GUI comes up – can be 1-2 min. not sure this two issues are related..
Changed USB FTDI adaptor – didn’t  help
Changed computer – didn’t help
Reset remote RRC – didn’t help
Installed ARCP-480 to see if I can control the Radio with different software – still can not control Radio

Any idea what can be the issue?

4
General discussion forum / Power drop in FT8 Hound mode
« on: 2020-02-05, 16:28:58 »
Hi

After some tweaks I am working standard FT8 with my TS480 w/o any issues. However, orking in F/H mode as Hound when the fax stations are RX on low audio freq, an my TX jumping to the low audio freq (~270hz) my output is attenuate (power signal drops ).

I made a test with another ham located 1 mile from my remote TX and my signal is +7DB (1200HZ audio) and drops down to -12 in 300HZ audion.

Is the RRC got a audio bandwidth limitation/filter in low audio freq?

thanks
Ziv

5
General / Re: App Period expired
« on: 2019-01-02, 19:05:33 »
HNY. can i pls get a reply ?

6
General / App Period expired
« on: 2018-12-09, 14:54:54 »
Hi


I got App Period expired but never had a chance to use it on my S8 phone. how can i try it and how can i buy it

thanks

Ziv
4Z4OQ

7
General discussion forum / Re: IC-2730 with RRC??
« on: 2016-12-16, 06:48:21 »
Mike???

8
General discussion forum / Re: IC-2730 with RRC??
« on: 2016-12-13, 18:40:26 »
Anyone??

9
General discussion forum / IC-2730 with RRC??
« on: 2016-12-12, 18:20:55 »
Hi
Would RRC support Icom VHF  IC-2730?

Thanks
Ziv

11
General discussion forum / Re: RF killing RR box at Remote.
« on: 2015-11-28, 09:53:51 »
Hi Frank

i had & have same problem. 80-60-40-30m bands. I could not TX more then 50-60w. What i did is adding snap ferrites on all the power lines that are 220v and 13.8V / Lan cables / cat232 cables. Now i can TX 500W on 80-40-30 without any problem.

TX on 60meters still "kills" my router connection but i think it is due to high SWR because i am loading via the KPA500 tuner the the 40meter dipole for 60m.
I will add a new dedicated dipole for this band and hope to solve this issue as well.

Good Luck
Ziv- 4Z4OQ

12
Hi

I was suffering from the same issue. I found that in most cases it was due to a very short electricity off/of at my radio location. Only reset (power off for 2-3sec) would help. Added small UPS and ok for 6 months

Ziv

13
General discussion forum / band sniffing via CAT com
« on: 2015-05-31, 15:29:35 »
Hi
I would like to build and band sniffing to my ts-480 with arduino software using a Y cable to the CAT com in order to control an ant switch. As I am building this on the remote site my question how can I stimulate this without traveling to the radio side.

Will the comport of the cat in the remote is same as at radio?

Thanka Ziv

14
General discussion forum / Moxa Nport W2150A for sale
« on: 2015-05-10, 13:17:18 »
Hi

Before advertising on eBay, I got NIB never used MOXA W2150 (lan/Wifi) 232 server (1 port)   – Asking 150 EU - shipping included

Ziv

15
General discussion forum / Re: TS-480 Voice Keyer Question
« on: 2015-04-06, 10:58:17 »
Hi John

do you have a PC connected to the RRC for digital mods? i have several recordings and  with different macros I send them as voice keyer

Ziv

Pages: [1] 2 3 ... 7