Messages

1

General discussion forum / Re: Issues when updating the RRC's Firmware using USB

« on: 2011-03-27, 19:26:30 »

Well,  I finally got to the user manual and see that the instructions are quite detailed.  Thanks.  I should have started there.  Hope you can fix the USB connection for firmware update.

2

General discussion forum / Re: Issues when updating the RRC's Firmware using USB

« on: 2011-03-27, 19:17:57 »

Can't update firmware via USB.  Connection seems fine but Write Failed.  Switched from USB2 to USB3 port, but still failed.

I tried connecting the Ethernet cable per earlier post, but USB update still failed.

I then went into setup and net info and had to change the default IP address to 192.168.10.50 to match my network.  Then I was able to connect via Ethernet to the "built in web interface" and from there I was able to update the firmware.  I had to figure a lot out because I hadn't found any real instructions other than the comment that the firmware could be updated via the web interface.  I did like the http interface on RemoteRig. 

For the USB attempts, here is the results of the infA12#.tmp program:

Microbit USB info v1.0:
USB:[Intel(R) 5 Series/3400 Series Chipset Family USB Enhanced Host Controller - 3B34]
USB:[USB Composite Device]
USB:[Intel(R) 5 Series/3400 Series Chipset Family USB Enhanced Host Controller - 3B3C]
USB:[NEC Electronics USB 3.0 Host Controller]
USB:[Generic USB Hub]
USB:[Generic USB Hub]
USB:[USB Root Hub]
USB:[USB Root Hub]
USB:[USB Composite Device]
USB:[USB Composite Device]
USB:[NEC Electronics USB 3.0 Root Hub]