Show Posts
1
General discussion forum / Re: ICOM CI-V and IC-9100
« on: 2011-09-15, 20:36:12 »
Hi Mike,
I have been using a remote rig with my IC-2820H and Love It.
I just purchased another Remote Rig for use with an IC-9100 and the Icom software they recommend.
I went through the set up at home and it worked fine on my local network. I moved the port settings up one from my original unit and both units connect without conflict.
Your instructions are not clear as for setting the COMM2. I first used ICOM CI-V, the audio was fine TX/RX and could key radio, but NO connection CI-V.
I changed the COMM2 settings to LOGICAL Parallel with COMM 0 and the CI-V and all others worked. The problem that developed is the TX audio went apparently high level and sounds real bad.
I am at the remote end right now, almost 600 miles from the radio. The ICOM software will not let me reduce the mic gain remotely. All seemed to work OK when I had both units local.
I noticed on the Remote Rig info group you said not to utilize the COMM2 serial settings. If I go with just the radio setting the CI-V will not work.
73
Art W1AGW
w1agw@cox.net
I have been using a remote rig with my IC-2820H and Love It.
I just purchased another Remote Rig for use with an IC-9100 and the Icom software they recommend.
I went through the set up at home and it worked fine on my local network. I moved the port settings up one from my original unit and both units connect without conflict.
Your instructions are not clear as for setting the COMM2. I first used ICOM CI-V, the audio was fine TX/RX and could key radio, but NO connection CI-V.
I changed the COMM2 settings to LOGICAL Parallel with COMM 0 and the CI-V and all others worked. The problem that developed is the TX audio went apparently high level and sounds real bad.
I am at the remote end right now, almost 600 miles from the radio. The ICOM software will not let me reduce the mic gain remotely. All seemed to work OK when I had both units local.
I noticed on the Remote Rig info group you said not to utilize the COMM2 serial settings. If I go with just the radio setting the CI-V will not work.
73
Art W1AGW
w1agw@cox.net