Messages

1

General discussion forum / Re: TS480 front panel is off

« on: 2011-05-13, 19:45:03 »

Ouah!!
Now all is ok!!!!!!!
Last problem was a default wire in an kenwood original cable-It's rarely-Now it's good-All equipments from Microbit was good of course!!thancks MIKE!!

2

General discussion forum / Re: TS480 front panel is off

« on: 2011-05-01, 18:29:43 »

ok mike many tks

3

General discussion forum / Re: TS480 front panel is off

« on: 2011-04-30, 16:37:33 »

Sorry,no change-Straps are ok-(connection type 1 for me)-what is "PTT status OFF" at the bottom of STATUS page-
tks

4

General discussion forum / Re: TS480 front panel is off

« on: 2011-04-25, 20:41:10 »

i am reset all boxes and firmware/software-now turn on/off front panel is ok-cables are ok-program nr 5 is ok-Audio RX is ok-But in tx no red led on front panel (only green),no power outpout and no audio from mike connected on the boxe-in the status page ,ptt is off-

5

General discussion forum / Re: TS480 front panel is off

« on: 2011-04-21, 20:44:40 »

Good evening Mike,
 I confirm that speed through the control box, radio box and the menu in ts480 is 57600- when I put the two wires one after another,directly between the front panel and the radio,turn  is ok- I'll check again  my two cables-73s Franck-

6

General discussion forum / Re: TS480 front panel is off

« on: 2011-04-21, 19:46:41 »

Hello
yes be sure! i use mod 4 but when i click on the connect/disconnect buttom i heard a litte noise in the speaker of detachable front panel but stay on OFF!!

7

General discussion forum / Re: TS480 front panel is off

« on: 2011-04-20, 22:19:28 »

thank you very much for your comments-I also use a ts480hx with the detachable remote control-panel I confirm that if I view the program 5, I don't see the  connect / disconnect button at the bottom of the menu "status "-The 2 rj cables are origin-the dc power is-ok

8

General discussion forum / TS480 front panel is off

« on: 2011-04-18, 21:41:26 »

I CONNECT THE 2 RRC MKII ON MY NETWORK INTERNAL -I VE PROGRAMMED THE EXAMPLE OF  PAGE 122 OF THE USER MANUAL FOR TS480-THE CONNECTION NOT ESTABLISHED BETWEEN THE TWO BOXES, THE RED AND YELLOW ARE OFF ON THE PLUG "AUX / MIC"-IF I REPLACED ON 2 BOXES PROGRAM IN EACH LINE MOD "5-TS480/TM-D710" 4- by -KENWOOD YAESU-Elecraft "THE CONNECTION IS ESTABLISHED BETWEEN THE 2 BOXES AND YELLOW LEDs ARE LIT BUT PRESSING  THE BUTTOM "ON/OFF" FRONT PANEL OF TS 480,THE FRONT PANEL IS OFF AND RADIO IS OFF-WHAT IS THE DIFFERENCE BETWEEN PROGRAM MODE- 4 AND PROGRAM MODE- 5-
PSE HELP ME-TKS