Messages

1

Hardware, Cabling, Installations / Re: ts 2000 straping

« on: 2011-09-12, 01:02:55 »

JMP-4 is placed behind the CW-pot, and is available only in the Control-RRC. JMP-4 is used to
select between Speaker level or Headset level for the Main-Rx output. is the jmp 4 on for speaker level or off for speaker level.    thank you SM0SHG

2

Hardware, Cabling, Installations / Re: ts 2000 straping

« on: 2011-09-11, 22:29:12 »

    is there a better picture somewhere should the jumpers be with the package? are they different  than the straps ?   Should they be with the shipment from the dealer  Ham Radio OUTLET?

3

Hardware, Cabling, Installations / Re: ts 2000 straping

« on: 2011-09-11, 17:55:56 »

i have looked at those pages and can not see the places to put the jumpers the straps i can see that but i don'see where to put jumper's 1,2,3,and4 is there a better picture any where , Is jump 3 cts and rts  already set or do i have to place a jumper?    thank you      are there holes for the jumpers like the socket?  i don't see the holes my vision is poor i can't see out of one eye. this step 6 page 21 "JMP-3 is placed next to the rear D-sub COM2 " i see no place to place a jumper.  Are  the jumpers the little red jumper wires is that correct?  

4

Hardware, Cabling, Installations / ts 2000 straping

« on: 2011-09-11, 04:22:30 »

i need help seting straps for my ts 2000  i can not find all of the strap points can someone help me?  where are jmp 1,2,3,and 4 ?  thank you.