Messages

1

Configuration, RRC 1258 / Re: Problems with Setup Manager on my new Windows-7 computer

« on: 2013-10-10, 15:56:12 »

Jan --- YES the USB cable is always connected to the RRC-1258. 

Did you try the run it with administrator rights ?  YES We have tried many different configurations.  The Setup Manager worked fine under Windows XP.

Guy ON4AOi

2

Configuration, RRC 1258 / Problems with Setup Manager on my new Windows-7 computer

« on: 2013-10-09, 19:22:28 »

My name is Terry and my call sign is W7KW.

Recently I changed the OS and hard disk  in my home computer from Windows XP Pro to Windows-7 and solid state drive.  After the upgrade I loaded "Microbit Setup Manager V 1.22.  The installation looked OK and I was able to select the specific profile I wanted, BUT, after that if I reopened Setup Manager and attempted to change to a different Profile I found that nothing was displayed in any of the tabs and there is a message printed in red in the bottom window that said "Unknown disconnect!" and I have lost control of Setup Manager.  This feature worked fine when I was running XP-Pro. Please help.  Thank you  Terry  (((W7KW.terry@gmail.com)))

3

General discussion forum / Re: DynDNS Problem

« on: 2012-12-06, 16:39:28 »

Problem resolved with help from SM2O.  Great support !!!  Thanks Mike

4

General discussion forum / Re: DynDNS Problem

« on: 2012-12-05, 15:17:22 »

Mike -- I will send you an email with a print screen attachment of the Status Page attached.

Terry

5

General discussion forum / Re: DynDNS Problem

« on: 2012-12-05, 14:00:28 »

Mike -  After I received your email I went back and checked the settings in the RRC DynDNS Results page.  It looks like the DynDNS feature on our system has never worked.  The Last update on the RRC DynDNS page was back in July 2012 and is still listed on my most recent check.  I also noticed that the Update count was listed as 1.  So I suspect that this is the first time the IP address has changed our IP address since the feature was installed 5 months ago. The RRC DynDNS Result lists the following.  Host <xdfze1xk> the Link field is <xdfze1xk.ddns.remoterig.com> , the IP is the origional IP <71.118.186.230> Last update was <2012-07-09 17:03:41> and the Update count is <1>  The Dynamic DNS settings on the 1258 (Radio) are set as follows: Dynamic DNS check interval is set <10> , Dynamic DNS host name i set <ddns.remoterig.com>.  Own Host name is <xdfze1xk.ddns.remoterig.com>, the Username is set <rrc1258-4634> and the password is set <z8ex52jb>.  In order th use the service I copied the Own host name and pasted it into the SIP address location in the control box configuration. I hope this information helps you pin point the problem. Let me know if you need anything else.

73 de Terry W7KW

6

General discussion forum / DynDNS Problem

« on: 2012-12-04, 19:11:37 »

The IP provider at my remote location has changed our IP address and my Microbit DynDNS software has not updated to the new address and I cannot connect.  I tested my ddns link address and it still shows the old IP address.

Please Help

73 de Terry W7KW