I have had the RRC-1258 MkIIs setup now for about 3 weeks and have really enjoyed working 10 meter SSB during my lunchbreak at work! So I tried to get the CW setup to work.... going on 1 week working on this and trying to find more info. I have tried exactly like the Manual says to do it, but it does not work. I am using the RRC with a Kenwood TS-2000X and an old bencher BY-1 iambic paddle. I can get the paddles to send a signal that is keying the radio and it is putting out a signal on CW, but it is not what I am sending. I have the CW monitor volume of the TS-2000 turned down to nothing so I do not hear the TS-2000. I am only listening to the RRC built in keyer. The RRC keyer sounds fine on the RRC unit and I can vary the speed fine and all seems to work fine at the remote end. I use a separate reciever and listen to the TX of the TS-2000. Depending on what settings I use it will either send dits, or dahs, or any combination of these, but never a dit and a dah correctly. Also the TS-2000 tx signal will not adjust in speed when I use the cw speed control on the RRC unit. I am at my witts end with this. I have checked all my cables, changed them, rewired them, and still does the same thing. I have tried the settings in the manual, and all others I thought might work. Nothing!!! Can someone please help me? A list of all of the settings that someone else is using that works fine with a TS-2000 would be great. I might have something set wrong on the TS-2000, if someone has a list of the settings for the TS-2000 menu settings that might be nice also.
Thanks in advance. Greg WQ0P