I have been using a set of 1258 MK II with a TS-480SAT for long distance remote operation. I have recently acquired an FT-950 that I wish to test in this mode. It has the latest system and DSP software installed. I wish to use the PCC for FT-950 Yaesu control program for rig remote control.
I can connect a PC running the control program directly to the FT-950 and it functions perfectly. I can not however find any combination of settings that will allow me to control the cat port through the 1258. The 1258 connect to each other without difficulty however I have no serial communication. I have carefully checked all my cabling so I am virtually certain it is a configuration difficulty. I have software 2.79 installed on both 1258.
I would appreciate any help the forum could provide as I do not have any further ideas as to how to configure the system. I am very much hoping someone has done this and can provide me a detailed setup for this configuration.
Yes, yes, I know that the TS 480 is superior for this application but that is not the point of this experiment.
Thank you in advance for any assistance you can provide.
